Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for inventum HotSpot Titanium 40131500
Summary of Contents for inventum HotSpot Titanium 40131500
- Page 1 MANUAL 4-litre Solo and 8-litre Combi www.hotspot-titanium.com...
-
Page 2: Conformity Statement
Houten, 6 October 2016 © 2016 No part of this guide may be reproduced and/or published by means of print, photocopy, microfilm or in any other way without prior permission of Inventum Technologies B.V. This also applies to the accompanying illustrations. -
Page 3: Table Of Contents
Table of contents USER GUIDE INSTALLATION GUIDE Installation Conformity statement Steps 1 to 5 How to use this guide Steps 6 to 15 Application Warranty Liability User guide illustrations Description The water heaters The boiling water taps Fig. 2.1 HotSpot Titanium 4-litre water heater Fig. -
Page 4: How To Use This Guide
You should register your product for is intended for you. warranty coverage within 3 months of purchase. Inventum Technologies B.V. compiled this guide • This can be done online at www.hotspot- with the greatest care. However, no rights may titanium.com. -
Page 5: Liability
1.3 Liability Inventum Technologies B.V. or your fitter/supplier accepts no liability for damage or physical injury of any kind caused by: • not following the instructions in this guide; • carelessness during the installation, use, maintenance and repair of this system;... -
Page 6: Scope Of Delivery
Scope of delivery Fig. 3.1 Package contents of water heater 3.1 Package contents of water heater After purchase, please check whether the following are supplied: HotSpot Titanium water heater tank HotSpot Titanium connection set User and installation guide To prevent dangerous situations, both the HotSpot Titanium water heater and HotSpot Titanium boiling water tap have to be installed by a registered professional in accordance with the supplied installation instructions. -
Page 7: Technical Specifications
In areas where the water hardness exceeds 12 °dH, Inventum Technologies B.V. recommends the use of a filter system with water softener. In areas with values above 14 °dH, Inventum Technologies B.V. stipulates the use of water softener with ion exchanger as a warranty condition. - Page 8 housing tap wire magnetic valve water heater housing sensor 2 water heater tank heating element sensor 1 control thermal protection sensor thermal protection power cord Fig. 3.2 Electrical wiring diagram...
-
Page 9: Operation
4 Operation This appliance is not intended for use by persons (including children) with physical, mental and/or visual limitations, or lack of knowledge and experience, unless supervised by a suitably qualified person. Please note that this appliance is not a toy! Parents and/or carers should prevent children from playing with it. -
Page 10: On/Off Button
4.1 On/off button Safety level 3: Almost identical to safety level 2, but the You switch the water heater on or off by press- system dispenses boiling water after you have ing the on/off button for at least 2 seconds. When the water heater is switched on, all LEDs pressed the electronic control button 3 times will light up briefly. -
Page 11: How To Use The Tap
4.3 How to use the tap 6 Malfunction The HotSpot Titanium uses an electronic con- The HotSpot Titanium boiling water tap is a trol button on the tap to let water flow from Dutch quality product developed on the basis the tap. -
Page 12: Malfunction Table
6.1 Malfunction table MALFUNCTION EXPLANATION SOLUTION Not enough water • Water pressure too low • Check another tap. If the pressure is too low, check the mains stopcock and contact the water company • Open the shutoff value • Shutoff valve is not properly open •... -
Page 13: Error Messages
6.2 Error messages If the controls detect an error, this is indicated by a flashing on/off LED. Furthermore, one or more LEDs will flash according to the following diagram: Boil dry protection – on/off and LED 1 are flashing Tap not connected – on/off and LED 3 are flashing Temperature sensor faulty –... -
Page 14: Installation
8 Installation • The inlet combination has a maximum relief pressure of 800 kPa (8 bar). • The inlet combination must be installed in a frost-free environment with the spout pointing downwards. Position the HotSpot Titanium boiling water tap according to the accompanying tap instructions. -
Page 15: Steps 6 To
If a filter is to be used, it must be installed Open the water mains stopcock and the before the inlet combination is installed. So water heater will partly fill with water. Check the inlet combination fits between the filter the system for leakages. - Page 16 E-mail: info@hotspot-titanium.com Powered by S A F E A N D T R U S T E D The HotSpot Titanium was designed and developed by Inventum. www.hotspot-titanium.com A 100% Dutch company with over 100 years of dedication, knowledge and expertise.