Table of Contents
Advertisement
a 、This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this devicemust accept anyinterference received,
including interference that may cause undesiredoperation.
b 、Any Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
c 、Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio ortelevision reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the followingmeasures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
d 、Specific Absorption Rate (SAR) information:
This data terminal meets the government's
requirements for exposure to radio waves. The guidelines
are based on standards that were developed by independent
scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all
persons regardless of age or health.
Wa r n i n g t i p s
Advertisement
Table of Contents
