Pump Alarm Cellular Water Manual

1. If you haven't already done so, please activate your unit. You'll visit www.PumpAlarm.com/activate,
then enter your unit's 6 digit alphanumeric unit number followed by your billing information. The unit
number is found at the top of your unit. After completing the form, we will generate the phone number
for your unit. Once you receive your number, please save it as a contact in your mobile device. We like to
simply name ours Cellular Alarm.
2. Remove (4) screws, lift lid and install (4) AAA Alkaline batteries. You can also use non-rechargeable
lithium batteries. Observe battery polarity. Negative end of the battery touches the spring in each holder.
Reinstall the lid.
3. Mount the Cellular Alarm unit to the sump pump discharge pipe about 4 ft above basin cover. Use two
of the included mounting straps. Unit can also be wall mounted.
4. Connect your choice of sensor into one of the inputs on the bottom of the unit. We recommend using