JABSCO 30520-1 Series Operating Instructions

SELF-PRIMING PUMPS
FEATURES
Pump Type: Pedestal Pump
Body: Epoxy Plastic
Impeller: Neoprene, Nitrile, Viton* or EPDM
Shaft Seal: Mechanical, Carbon-on-Ceramic, or
Tungsten Carbide; Nitrile or Viton
Ports: 1" NPT External
Shaft: Epoxy Plastic Covered Stainless
Steel
Weight: 7.0 lb (3.2 kg) Approx.
VARIATIONS AVAILABLE
MODEL NO. DESCRIPTION
30520-1001 Standard Pressure, Neoprene
Impeller, Carbon Seal
30520-1003 Standard Pressure, Nitrile Impeller,
Carbon Seal
30520-1004 Standard Pressure, Viton Impeller,
Carbon Seal
30520-1011 High Pressure, Neoprene Impeller,
Carbon Seal
30520-1013 High Pressure, Nitrile Impeller,
Carbon Seal
30520-1014 High Pressure, Viton Impeller,
Carbon Seal
30520-1101 Standard Pressure, Neoprene
Impeller, Tungsten Carbide Seal
30520-1103 Standard Pressure, Nitrile Impeller,
Tungsten Carbide Seal
30520-1104 Standard Pressure, Viton Impeller,
Tungsten Carbide Seal
30520-1111
High Pressure, Neoprene Impeller,
Tungsten Carbide Seal
30520-1113 High Pressure, Nitrile Impeller,
Tungsten Carbide Seal
30520-1114 High Pressure, Viton Impeller,
Tungsten Carbide Seal
APPLICATIONS
I N D U S T R I A L : Circulating and transferring corrosive liquids.
Returning spilled liquids to process, transferring foaming
solutions with entrained air, such as soaps and detergents.
Sampling and pilot plant installations. Handles pure solutions,
acids, alkalies, photo chemicals, dyes, detergents, waxes,
gels, solutions with suspended solids and emulsions.
* Viton is a trademark of E.I. Du Pont de Nemours and Company.
PumpAgents.com - buy pumps and parts online
www.PumpAgents.com
PumpAgents.com - Click here for Pricing/Ordering
Models 30520-1XXX
M E TA L P L AT I N G : Filtration of plating solutions. Filling and
emptying vats. Adding chemicals for pH balance.
P H A R M A C E U T I C A L : Processing lab solutions, medicines,
lotions and preparations. Filtering pharmaceutical solutions.
A G R I C U LT U R A L : Transferring liquid fertilizers, herbicides
and pesticides.
OPERATING INSTRUCTIONS
1. INSTALLATION – Pump may be mounted in any
position. The rotation of the pump shaft determines
the location of the pump's intake and discharge
ports. (Refer to dimensional drawing.) Pump is
normally assembled at factory for clockwise rotation
(looking at end cover). If counter clockwise rotation
is desired, follow steps 1 and 2 of disassembly and
step 9 of assembly instructions to change direction
of impeller blade deflection under cam.
2. DRIVE – Belt or direct with flexible coupling.
Belt Drive: Over tight belt load will reduce pump
b e a r i n g life.
Direct Drive: Clearance should be left between drive
shaft and pump shaft when installing coupling.
Always mount and align pump and drive shaft before
t i g h t e n i n g the coupling set screw. If pulley or
coupling must be pressed on shaft, remove end
cover and impeller to support shaft from impeller end
during press operation. Do not hammer pulley or
coupling on shaft; this may damage bearing or seal.