Table of Contents
Advertisement
During automatic operation, alarm messages can appear on the screen - reset these
messages by holding down the key with the green check mark on it.
ALARM "Error front bumper"
The front bumper touched something while in AUTOMATIC mode.
Remove the obstacle and then press
-
-
From the main menu go to [AUTO].
Check whether there is a value at "PATH LENGTH x.xx M" which is the same as the
-
distance that the METO has travelled.
-
If the distance is correct, the METO spraying machine can be restarted via START,
and then after about 5 seconds it will start moving again.
-
If the distance does not correspond, you must reverse the METO manually [AUTO
REVERSE]. After operating the start button, the METO will reverse off the pipe rails
automatically at half speed after 5 seconds have elapsed.
-
During the 5 second delay, please step back from the METO to a safe distance.
ALARM "Error rear bumper"
The rear bumper touched something while in AUTOMATIC mode.
(See the "METO front bumper" description)
ALARM "Error rail detection forwards or rail detection backwards"
The pipe detection in AUTOMATIC mode has dropped out during driving.
Check if the pipe detector is working properly, consult the supplier if necessary.
ALARM "Error counting"
Counting in AUTOMATIC mode has dropped out.
Check for the proper operation of the measuring wheel sensor (warning lamps lit at each
bolt on the plastic disc!). Check whether "speed forwards" and "speed backwards" are both
set.
ALARM "Error METO has not reached the rail"
The METO spraying machine in AUTOMATIC mode has not reached the pipes in the preset
time (normally 4 seconds).
ALARM "Error rail remains detected"
The METO detects in the AUTOMATIC mode after the START button was pressed that the
METO-spray trolley is already on the rails or that the role is still in the highest position.
Check the correct operation of the pipe detection role.
ALARM "METO is not good at the METO TRANS"
Only applicable if the METO Trans is used.
The METO is no longer in the correct starting position in the METO TRANS, drive in manual
mode the METO fully rearward in the METO TRANS.
ALARM "low battery voltage - charge battery!"
The METO spraying machine batteries must be recharged, automatic spraying is no longer
possible. The METO always sprays the path completely if this error occurs.
ALARM "Error motor drive "
The drive motor regulator is faulty - switch the METO off and on, then check if it moves
again.
Translated user manual V6_EN
.
METO 1500XXXTS
27 / 47
Advertisement
Table of Contents
