6. Storage ......10 1. Specifications & Technical Information Machine Specification Model RT-40A RT-60A Weight 2.6kg 2.8kg...
Page 4
Front of Machine Window Release lever Adjusting knob Arm A unit Main switch Machine mouth Curl guide Trigger lock Cover Handle Trigger Battery lock button Back of Machine Wire guide C Wire coil Reel stopper Reel stay...
Page 5
Battery Battery cover Battery terminals Battery lock Charger Power cord Main plug Charger terminals...
2. Safety 12. Ensure trigger lock is on and power switched off when charging battery. This machine is a high performance, battery 13. Do not expose machine to operated tool. Failure to follow safety wet or damp conditions. instructions may result in serious injury. 14.
14. Ensure new batteries or batteries which haven’t been used for some time are fully charged before use. 15. Handle charger cord carefully. Do not carry charger by cord or unplug charger by pulling cord. 16. Make sure battery terminals do not come into contact with each other.
4. Machine Operation Reel stay Always read, understand and comply with safety instructions (Section 2) before use. Battery Saving Function The machine is equipped with a battery saving function and will automatically shut down after 10 minutes of no use. 3.
Page 9
6. Make sure that the wire is tight and firm. Reel stopper Prevent the wire from curling up behind the wire coil. This may cause a jam. Reel stay Push the reel stopper to release the reel stay and open it at the same time, remove the wire coil.
5. Maintenance Correct Usage Machine is equipped with advanced warning detection features. If the machine emits a warning sound, contact an authorized service centre for diagnosis before further use. Never attempt to service machine other than general maintenance procedures below. Contact an authorized service centre if issues arise.
Page 12
RAPID TOOL AUSTRALIA Leading distributor of specialist construction tools & equipment www.rapidtool.com.au...