Workshop VAG 1761/1 Operating Instructions

Operating Instructions–VAG 1761/1
Compressed air gun
For processing Spray-on seam sealant D 476 KD7 A3 and other 310 ml cartridges

Processing D 476 KD7 A3 Spray-on Sealant

1
1. Opening cartridge
Press in flanged cover of aluminium cartridge using tool
supplied. Pierce membrane of nozzle connection using
drift.
2
2. Preparing cartridge
Screw material nozzle hand-tight onto cartridge.
3
3. Inserting cartridge
Push cartridge into receiver pipe on gun. Screw blue SN
union nut securely onto tube.
= Screw-on nozzle
A
= Tool for piercing
B
Aluminium cartridges
SN = SN union nut for processing spray-on seam sealant
DK = DK union nut for tensioning cartridges with multi-purpose
application
Compressed air connection
The screw-on nozzle provided fits into the rectus / EWO coupling.
Screw the nozzle into the thread on the gun handle. Appropriate
nozzles must be used with other coupling systems.
Plastic or rubber hoses with a nominal width of 6 mm and minimum
operating pressure of 10 bar at +60 °C are recommended for the
compressed air hose.
4
4. Screwing on air jet
Screw air jet into SN union nut to the stop. Compressed
air regulation: The compressed air gun is equipped with
a dual circuit air system! The supply pressure should be at
least 7 bar. Higher supply pressure is automatically reduced.
5
Spray
5. Adjusting screws
The flow of material and the spray air can be adjusted
independently of each other using the adjusting screws
on the gun.
Red adjusting screw = Flow of material
Blue adjusting screw = Spray air
Material
(continued on next page)