Summary of Contents for FISNAR EP1320C
- Page 1 Rev. A - November, 2013 EP1320C OPERATION MANUAL CARTRIDGE PUMP MODEL EP1320C ◀OPERATION MANUAL▶ P a g e...
-
Page 2: Table Of Contents
Rev. A - November, 2013 EP1320C OPERATION MANUAL CONTENTS 1. Safety - - - - - - - - - - - - - - - - - - - - - - - - - 3 2. Introduction - - - - - - - - - - - - - - - - - - - - - - - - - 7 3. -
Page 3: Safety
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 1 GENERAL SAFETY WARNINGS 1. Equipment Misuse Hazards Any misuse of the dispensing equipment or accessories such as over- pressurizing, modifying parts, using incompatible chemicals and fluids, or using worn or damaged parts, can cause item to rupture and result in fluid splashing in the eyes or on to the skin. - Page 4 Rev. A - November, 2013 EP1320C OPERATION MANUAL 2. Hose Safety – High Pressure Hazards High pressure fluid in the hoses can be very dangerous. If the hose develops a leak, split or rupture due to any kind of wear, damage or misuse, the high pressure spray emitted from it can cause material to splash in the eyes or on the skin.
- Page 5 Rev. A - November, 2013 EP1320C OPERATION MANUAL 3. Moving Parts Hazards In order to lessen the danger of an accident, keep hands and fingers away from the priming piston while the pump is installed and while air is introduced to the pump.
- Page 6 Rev. A - November, 2013 EP1320C OPERATION MANUAL 4. Fire and Explosion Hazards Static electricity may occur while fluid is in circulation through the pump and hose. When not properly grounded, a spark may occur which can be dangerous. It can occur whether the power cord is plugged or not.
-
Page 7: Introduction
SECTION 2 INTRODUCTION The EP1320C is a powerful medium ratio system for controlled fluid transfer from 1/10 gallon (310ml) plastic cartridges – suitable for silicone-type fluids. The system integrates a dual (A+B) tandem cartridge arrangement for continuous-flow management. A low- pulse design allows automatic control of dispensing application. -
Page 8: Specification
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 3 SPECIFICATION Power Requirements 220VAC ± 10%, 50-60Hz Power Consumption Max Air Inlet 9.9kgf/cm Pump Ratio 15:1 Weight 18.5kg Temperature Range C ~ 40 272mm (W) Dimension 288mm (D) 649mm (H) -
Page 9: Control Panel
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 4 Control Panel P a g e... - Page 10 Rev. A - November, 2013 EP1320C OPERATION MANUAL Menu Operation Description Lamp is on when power on Lamp is off when power of Power On/Off switch Cartridge is empty when light Lamp On/Off is ON. Indicates which side cartridge is being used and/or replaced...
-
Page 11: Installation / Set-Up / Operation
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 5 INSTALLATION / SET-UP / OPERATION 1. Installation Air Line Connections Connect one end of the fluid line to the fluid inlet of the dispensing valve and the other to the fluid outlet of the pump. - Page 12 Rev. A - November, 2013 EP1320C OPERATION MANUAL 2. Set-Up Installing / Replacing the Cartridge Turn the cartridge holder counter clockwise and pull to remove. Insert the cartridge with the outlet facing down. Replace the cartridge holder. Turn in clockwise direction to lock and secure.
- Page 13 Rev. A - November, 2013 EP1320C OPERATION MANUAL 3. Operation Operation Set the main air regulator (A) to the required dispense pressure. Open the bleed port (C) to extract bubbles and close slowly. Set air pressure over 30psi with air regulator (B).
-
Page 14: Troubleshooting
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 6 TROUBLESHOOTING ISOLATE ALL AIR AND MATERIAL FEEDS FROM THE PUMP PRIOR TO SERVICING. 고장 Pump does not work. PUMP가 작동하지 않는다. Pump stroke is short. PUMP는 작동하지만 STROKE가 작다. Flow rate is slower than usual PUMP는... -
Page 15: Exploded View / Parts List
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 7 EXPLODED VIEW AND PARTS LIST 1. Main Body 15 | P a g e... - Page 16 Rev. A - November, 2013 EP1320C OPERATION MANUAL Part No. Description Material Quantity CARTRIGE CAP AL6061 O-RING SENSER MAGNET HOLDER PIPE STS304 SENSER MAGNET BALL VALVE PIN CONNECTOR STS304 INLET HOUSING AL6061 O-RING MANIFOLD AL6061 15A,B BLEED COCK BLEED COCK...
- Page 17 Rev. A - November, 2013 EP1320C OPERATION MANUAL 2. Pump Head 17 | P a g e...
- Page 18 Rev. A - November, 2013 EP1320C OPERATION MANUAL Part No. Description Size 101-1 PUMP HEAD BOX COVER PUMP HEAD PCB 101-2 LED LAMP(G.Y.R) SPACE BAR-1 M3*10 101-3 PCB PLATE SOLENOID VALVE SY5140-5LZ(SMC) 101-5 POWER CORD 2P 220V PUMP HEAD BOX COVER...
- Page 19 Rev. A - November, 2013 EP1320C OPERATION MANUAL Part No. Description Size 106-1 PUMP SHAFT-2 106-2 PUMP SHAFT-3 106-3 PUMP SHAFT-4 SPRING PIN 3Ø, 15 PUMP UNDER SHAFT OIL CUP 107-1 O-RING PUMP V-PACKING PUSHER-1 108-1 PUMP V-PACKING PUSHER-2 108-2...
-
Page 20: Dimensions
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 8 DIMENSIONS 20 | P a g e... -
Page 21: Technical Data
Rev. A - November, 2013 EP1320C OPERATION MANUAL SECTION 9 TECHNICAL DATA Maximum fluid dispensing pressure- - - - - - - - - - - - - - - - - - - - - - 60Kg/Cm Air pressure range input - - - - - - - - - - - - - - - - - - - - - - - - - 1.8~7.0Kg/Cm Maximum fluid viscosity - - - - - - - - - - - - - - - - - - - - - - - - - - - 600,000 cps Dispensing volume per a stroke - - - - - - - - - - - - - - - - - - - - - - - - - - - 5.0cc...
Need help?
Do you have a question about the EP1320C and is the answer not in the manual?
Questions and answers