Salton Platinum Series Instruction Booklet page 6

Nozzle onto the Steam Nozzle Hanger until
it is secured in place. See Illustration 2A.
5. Align the 3 holes in the back of the Water
Reservoir with the 3 hooks protruding from
the front of the Wall Mounting Base. Press
the Water Reservoir onto the Wall Mounting
Base. Once attached, slide the Water Reservoir down to secure onto
the Wall Mounting Base. See Illustration 2B. NOTE: The Fabric Steamer
can be used while on the Wall Mounting Base or removed and placed
on a table or countertop.
Fabric Brush Attachment
The Fabric Brush attachment is used in conjunction
with the Steam Nozzle. To attach this accessory:
1. Unlock the Fabric Brush by turning the Lock
clockwise until it stops (Ill. 3A)
2. Slide the Fabric Brush over the Ironing Plate
until it stops (Ill. 3B) CAUTION: Use care
when attaching the Fabric Brush as the Iron
Plate may be hot. Do not attempt to attach
the Fabric Brush while the unit is emitting steam.
3. Turn the Fabric Brush lock counterclockwise
until it is locked. (Ill. 3C)
4. The Fabric Brush is now fastened securely
and you are ready to begin steaming.
HOW TO USE
Filling the Water Reservoir
1. Press the On/Off Switch to the 'Off' position. Unplug
the Power Cord.
2. Open the Lid of the Water Reservoir and turn the Water Reservoir Cap
about a quarter of a turn, counterclockwise. Remove.
3. Using the Measuring Cup that is included with the unit, fill the Water
Reservoir with a maximum of 27 oz. (800 ml) of cold water.
Ill. 2A
Ill. 2B
Ill. 3A
Unlocked
Ill. 3B
Ill. 3C
Locked
6