Advertisement
Figure 11
3.9
Repeat this procedure for the
other seal drive half.
4
Seal Drive Split Joint
Gasket Installation
4.1
Wipe the seal drive's split joint
gasket groove clean with
alcohol.
Caution: Consult material safety data sheets
for proper handling of alcohol.
4.2
Put one dot of adhesive near the
inner corner. See Figure 12.
4.3
Put one dot of adhesive near the
outer corner. See Figure 13.
4.4
Place the split joint gasket in the
groove and position it as shown
in Figure 4. Hold it in place for
10 seconds. See Figure 14.
4.5
Repeat this procedure for the
other seal drive half.
3.7
Repeat these steps for
the rotating face gasket.
3.8
Push the draped middle of
the sleeve gasket and
rotating face gasket into
their grooves. Do not
apply adhesive.
See Figure 11.
Figure 12
Figure 13
Figure 14
7
Advertisement
