Getting Started; Sd Memory Card; Checking Battery Level - Ridgetec Lookout Instruction Manual

GETTING STARTED

Please visit the following link for complete instructions on setting up camera on the portal:
https://portal.ridgetec.com/help/quick-start

SD MEMORY CARD

The camera supports both SD and SDHC memory cards up to 64 GB. The camera does
not have any internal memory and will not work without SD card inserted.
1. Open camera
2. Insert SD card with orientation as shown next to slot on camera
3. Push gently until card clicks into place
4. Push card again to remove
Note 1: Ensure SD card is NOT in locked position.
Note 2: Format SD card in camera before using each time. This will create a file on the SD
card where the camera will save images to.
Note 3: It is always recommended to test the SD card by taking some pictures to ensure
SD card works properly before leaving camera for extended periods of time.
WARNING: Make sure camera is OFF when adding or removing SD memory card.
BATTERIES
This camera is designed for Lithium batteries for optimal performance (rechargeable
batteries may not have sufficient voltage to run the camera properly). An AC to DC power
cord (sold separately) can be attached to the bottom port of the camera.
Insert 12 AA batteries while ensuring polarity (+ -) is correctly orientated.
Note: 9V or 12V DC power can be used. It is recommended to remove internal AA batteries
when using external power to reduce the possible battery leak. Solar panels DO NOT
charge batteries directly located in the camera but are often used to charge external
battery.

CHECKING BATTERY LEVEL

Battery level can be seen in bottom left corner of viewer screen
TESTING AND WORKING MODES
The camera has two modes: SETUP Mode and ON Mode.
Page | 4