Advertisement
Quick Links
Advertisement
Summary of Contents for E17 UG15-76A
- Page 1 RANGE HOOD INSTRUCTION MANUAL...
- Page 3 Product Specification & Technical Parameters UG15-76A Model Rated Voltage 120V/60Hz Light Power LED 2*2W 230W Motor Power 234W Total Power Air outlet diameter RECOMMENDATIONS AND SUGGESTIONS INSTALLATION * The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
-
Page 4: Maintenance
* The range hood has been designed only for domestic use to eliminate kitchen fumes. * Never use the hood for purposes other than what it has been designed for. * Never leave high naked flames under the hood when it is in operation. * Adjust the flame intensity to direct it onto the bottom of the pan only;... - Page 5 * TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. b) Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting.
-
Page 6: Installation And Use
DIMENSIONS INSTALLATION & USE OPERATION OF CONTROLS • The hood is operated using the touch control. • The on/off switch turns the hood on and off. • The light switch turns the lamps on and off. The blower switch turns the blower on to three speed settings: Low speed Medium speed High speed... -
Page 7: Install The Ductwork
INSTALL THE DUCTWORK (DUCTED HOODS ONLY) 1. To reduce the risk of fire, use only metal ductwork . Decide where the ductwork will run between the hood and the outside. 3. A straight, short duct run will allow the hood to perform most efficiently. 4. - Page 8 25 1/2’’ 1.When you fix the location to hang the hood, use 3pcs screw ST5*45 and 3pcs plastic screw to fix the bracket for hood on the wall. 2.Unscrew the 4pcs M4*10 screw on top and use them to fix the air outlet base on the air system top.
- Page 9 6.Put the second chimney inside of the first chimney and adjust the length as required. Use 2pcs screws ST4.2*30 to fix the bracket for chimney on the wall. 7.Use 2pcs screw M4*6 to fix the second chimney on the bracket. 8.