Hyundai Elantra GT 2013 Owner's Manual page 28

Removal
• To remove the headrest, raise it as
far as it can go then press the
release button (1) while pulling
upward (2).
• To reinstall the headrest, put the
headrest poles (3) into the holes
while pressing the release button
(1). Then adjust it to the appropri-
ate height.
• Make sure the headrest locks in
position after adjusting it to proper-
ly protect the occupants.
■
Type A
OGDE031010
■
Type B
Seat warmer (if equipped)
The seat warmer is provided to warm
the front seats during cold weather.
Safety features of your vehicle
With the ignition switch in the ON
position, push either of the switches
to warm the driver's seat or the front
passenger's seat.
During mild weather or under condi-
tions where the operation of the seat
warmer is not needed, keep the
switches in the OFF position.
• Each time you push the button, the
temperature setting of the seat is
changed as follows :
OGD032014N
OFF → HIGH(
• The seat warmer defaults to the
OFF position whenever the ignition
switch is turned on.
• With the seat warmer switch in the
ON position, the heating system in
the seat turns off or on automati-
cally depending on the seat tem-
perature.
OGD032015N
) → LOW(
)
3 9