Table of Contents
Advertisement
EN
LEGOS1/LEGOS3
OPERATION MANUAL
SIGNALS
S
TATUS OF CENTRAL UNIT
Arming by remote control
Arming without internal lift and tilt sensor (LEGOS 3)
Arming with open contact
Initial immunity phase
Testing during the initial immunity phase
Central unit armed
Alarm cycles
Disarming without alarms
Disarming when the motorcycle's battery is flat
Disarming when alarms have been memorised
M
EMORISED ALARMS
Internal movement sensor
Contacts
Ignition sensing
If various alarms have been triggered, the memory will signal them in a sequence with 3 second pauses and will repeat the sequence
every 6 seconds.
The memory is reset when the motorcycle is started up or when the alarm system is armed with the remote control again.
MotorCycle Alarm
D
LED
IRECTION
Slow flashing
1 short flash
Flashing
2 flashes
On fixed during initial immunity phase
flashes 2 + 1
Flashing
2 flashes
Reversed flashing
Reversed flashing
Flashing
Flashing
lampeggianti
Switches off
1 flash
Switches off
Switches off briefly every 6 sec.
1 B
EEP
LED
1 flash
2 flashes
3 flashes
11
by
EN
I
S
NDICATORS
IREN
1 B
EEP
2 B
EEP
B
2 + 1
EEP
2 B
-1 B
EEP
OOP
1 B
EEP
Sounds
1 B
EEP
4 B
EEP
- 1 B
OOP
SIGNALS
Advertisement
Table of Contents
Related Manuals for Meta System LEGOS1
Summary of Contents for Meta System LEGOS1
- Page 1 LEGOS1/LEGOS3 MotorCycle Alarm OPERATION MANUAL SIGNALS TATUS OF CENTRAL UNIT IRECTION NDICATORS IREN Passive arming Slow flashing 1 short flash Arming by remote control Flashing 2 flashes Arming without internal lift and tilt sensor (LEGOS 3) On fixed during initial immunity phase...
- Page 2 PASSIVE ARMING The central unit arms automatically in 50 seconds: - After the motorcycle’s key has been turned OFF, or - After the remote control has been pressed to disarm the alarm system, or - After the alarm system has been disarmed using the ‘override’ code. The passive arming is signalled by a short flash of the direction indicators, by a BIP from the siren, the very slow flashing of the LED;...
- Page 3 PROTECTION BY THE ALARM SYSTEM The alarm central unit protects the motorcycle against being started and an alarm cycle will be triggered every time: - the ignition key is turned ON - an attempt is made to remove or move any part of the motorcycle which is protected by specific switches (for example if the seat or the storage compartment is opened …...
- Page 4 PANIC (LEGOS 3) It is possible to trigger a 10 second alarm cycle by pressing the second button on the remote control. This alarm cycle can be interrupted by pressing the same button again. SPECIAL FUNCTIONS – CONFIGURATION It is possible to set some alarm functions to adapt the alarm system to the motorcycle and its driver’s needs. To set the functions, which are described in the table below, proceed as follows: 1.
- Page 5 ‘OVERRIDE’ EMERGENCY CODE If a remote control is lost, stolen or damaged, it is possible to disarm the alarm system with a 5 digit emergency code called the ‘OVERRIDE’ code. The code is found on the label supplied with the remote controls. This label must be kept in a safe place and not with the motorcycle.
- Page 6 CUSTOMISING THE ‘OVERRIDE’ CODE It is possible to customise the ‘override’ code so that it is easier to remember in case of emergency. Proceed as follows: WITHIN WITHIN WITHIN ‘OVERRIDE’ WITHIN WITHIN EMERGENCY CODE 1 3 2 1 2 2 Beep 2 Boop A B C D E 1 3 2 1 2...
- Page 7 RESTORING THE DEFAULT OVERRIDE CODE Should the driver forget or lose the override code for the product, the ‘11111’ default override code can be restored provided he has two remote controls. Follow the procedure below to do this: Disarm the product using the remote control, turn the motorcycle’s ignition key to ON and press button 1 alternately on both remote controls (remote control n°7 neutralised) twice.
Need help?
Do you have a question about the LEGOS1 and is the answer not in the manual?
Questions and answers