Advertisement
Quick Links
Repair Instructions and Parts List
Pressure Washers
This manual contains important
warnings and information.
READ AND KEEP FOR REFERENCE.
INSTRUCTIONS
APS2730H
Model 246798, Series A
2700 psi (186 bar, 18.6 MPa) Operating Pressure
3000 psi (210 bar, 21.0 MPa) Maximum Working
Pressure
APS3030H
Model 246799, Series A
3000 psi (210 bar, 21.0 MPa) Operating Pressure
3300 psi (227.5 bar, 22.75 MPa) Maximum
Working Pressure
Related manuals
. . . . . . .
309886
Parts
Manufactured by
Warnings
Component Identification
Pressure Relief Procedure
Pump Service
Parts Drawing
ASM Warranty
APS3030H Pressure Washer
Model 246799 Shown
309887B
Table of Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ti1025
2
3
4
8
12
16
Advertisement
Summary of Contents for Allpro APS2730H
- Page 1 This manual contains important warnings and information. READ AND KEEP FOR REFERENCE. INSTRUCTIONS APS2730H Table of Contents Model 246798, Series A Warnings ........
- Page 2 WARNING FUEL HAZARD The fuel used in this equipment is flammable. When spilled on a hot surface it can ignite and cause a fire. Do not fill fuel tank while engine is running or hot. INJECTION HAZARD Spray from gun, leaks or ruptured components can inject fluid into your body and cause an extremely serious injury, including the need for amputation.
-
Page 3: Component Identification
Component Identification High Pressure Hose Con- Pressure Unloader On/Off Engine Switch (side) nection and Garden Hose Adjustment Knob Connection high pressure hose connection garden hose connection Hose Tip Storage Engine Oil Fill Hydraulic Fluid Fill Oil Level Site Gage Gun and wand 309887... - Page 4 Pressure Relief Follow these instructions whenever you are instructed to relieve pressure, stop spraying for more than 10 minutes, check or service the equipment, or install or clean the spray nozzle. 1. Engage trigger safety latch. 2. Turn Pressure Washer off and remove ignition cable from spark plug.
-
Page 5: Maintenance Chart
Maintenance Chart Relieve pressure, page 4. Interval What to do Daily Clean water inlet screen and filter. Check engine and pump oil levels. Fill as necessary. Check gasoline level. Fill as necessary. After first Change engine break-in oil. Drain oil when warm. Use SAE 30 or 10W–30 detergent oil. 5 hours of operation After every... -
Page 6: Troubleshooting
Troubleshooting Relieve pressure, page 4. Problem Cause Solution Engine will not start or No gasoline in fuel tank or carburetor Fill tank with gasoline, open fuel shutoff valve. is hard to start. Check fuel line and carburetor. Low oil Add oil to proper level. Start/Stop switch in STOP position Move switch to START position Water in fuel or old fuel... - Page 7 Problem Cause Solution Packings are failing Scored, damaged, or worn plungers Install new plungers. freq entl or frequently or Abrasive material in fluid being pumped Install proper filtration on pump inlet plumbing. prematurely prematurely Inlet water temperature too high Check water temperature. It should not exceed 160_F (70_C).
- Page 8 Pump Service: APS2730H Repair kits are available. See the Parts Lists (page 12). For the best results, use all parts in the kits. Relieve pressure, page 4. NOTES: 3. Remove plunger and flinger from plunger shaft. Clean parts as necessary.
- Page 9 Servicing V-Packings 6. Lightly grease packing cavities and replace the packings in the following order: head ring, v-pack- 1. Remove manifold as outlined in Pumping Section ing, intermediate ring, head ring, v-packing, pack- on page 8. ing retainer. Install o-ring in retainer groove. 2.
- Page 10 Pump Service: APS3030H Repair kits are available. See the Parts Lists (page 14). For the best results, use all parts in the kits. Relieve pressure, page 4. NOTES: 2. Remove nut from plunger and examine o-ring, backup ring, and copper bearing/gasket washer. D Metric wrenches needed: 6 mm, 13 mm, 27 mm.
- Page 11 Servicing V-Packings 5. Thoroughly clean packing cavities. Examine for debris or damage. NOTE: There are two types of packing kits: One is packings only. The other includes packings, o–rings 6. Lightly grease packing cavities. Replace packings and retainers. in the following order: head ring, v-packing, inter- 1.
- Page 12 Parts: APS2730H Model Nos. 246798 Series A, with Honda 6.5 HP Motor 39, 27 8–12 38, 15 ti1612a *internal replacement parts 309887...
- Page 13 Parts: APS2730H Model Nos. 246798, Series A with Honda 6.5 HP Motor Ref. Part No. Description Qty. Ref. Part No. Description Qty. 15A405 ENGINE, gasoline 6.5 HP 15A401 SPRING, compression Honda 15A402 SCREW, cap 245585 PUMP, water 2700, 15A483 WASHER, flat...
- Page 14 Parts: APS3030H Model Nos. 246799, Series A with Honda 9 HP Motor 8–12 40, 27 39,15 ti1613a *internal replacement parts 309887...
- Page 15 Parts: APS3030H Model Nos. 246799, Series A with Honda 9 HP Motor Ref. Part No. Description Qty. Ref. Part No. Description Qty. 15A389 ENGINE, GX270 15A483 WASHER, flat 245580 PUMP, water 3000 15A484 NUT, lock 245422 KIT, frame, includes 15A495 FOOT, rubber wheels, feet, and tip 15A493...
- Page 16 ASM Standard Warranty ASM warrants all equipment referenced in this document which is manufactured by ASM and bearing its name to be free from defects in material and workmanship on the date of sale by an authorized ASM distributor to the original purchaser for use. With the exception of any special, extended, or limited warranty published by ASM, ASM will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by ASM to be defective.
Need help?
Do you have a question about the APS2730H and is the answer not in the manual?
Questions and answers