Summary of Contents for Walabot HOME
- Page 1 Walabot HOME to monitor your safety. Walabot HOME Device Setup Guide If you need assistance setting up your device please contact HomeSupport@Walabot.com For more information please visit: www.walabothome.com...
-
Page 2: Congratulations On Your Purchase
Walabot HOME Overview – Meet Your New Device Congratulations on your purchase of a Walabot HOME device. Walabot HOME uses smart motion sensing technology to monitor your safety. It is currently designed and optimized for bathroom use. Once installed, it can automatically tell if you fell by analyzing the entire bathroom space. - Page 3 Overview Warnings Warnings Table of Contents 1. The Walabot HOME device can break if 1. Package Contents dropped from heights of 2.5 feet (76cm) and above. 2. Installation and Setup Instructions 2. Using a power adaptor other than the Step 1: Mount the device on the bathroom wall...
- Page 4 FCC Regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
-
Page 5: Package Contents
• Power adaptor 3. The maximum size of a bathroom that the • Four double-sided stickers Walabot HOME can support is 10 x 10 feet. • Device Setup Guide 4. Walabot HOME may not function • Emergency Contact Setup Guide... - Page 6 Step 1: Mount the device on the bathroom wall Set correct time zone Take your Walabot HOME out of the box If at any point you need to change and into the bathroom for installation. your time zone, you can go to the device’s ‘Settings’...
-
Page 7: Step 8: Installation Complete
(continued) Congratulations, you’re done. How to apply & remove stickers. Look for a good location: Your Walabot HOME is now fully • Walabot HOME should be installed and ready to act in the placed close to the center of event of a fall. - Page 8 Step 7: Test the device Step 3: Read the End-User It is extremely important to perform a test Agreement run, to make sure your Walabot HOME is properly installed. Read the End-User License Agreement. To begin, carefully lay down on the You will need to scroll down to get to the ground.
- Page 9 Now click the ‘Code Generator’ onscreen, to create a code. Give this code to your emergency contact, to enter in the Walabot HOME app (you will either need to read it to them, or write it down and send). Once your emergency contact enters this code on their phone, you are successfully paired.
Need help?
Do you have a question about the HOME and is the answer not in the manual?
Questions and answers