Subscribe to Our Youtube Channel
Related Manuals for Balcrank Synergy 3110-021
Summary of Contents for Balcrank Synergy 3110-021
- Page 1 Tank Surveillance Module 3110-021 Synergy Monitoring System SERVICE BULLETIN SB 3077 Rev. A 3/12...
-
Page 2: Table Of Contents
ONNECTING A FRESH OIL TANK EVEL 7.2. 23132 (2-L ) .................. 8 ONNECTING A WASTE OIL TANK EVELS 8. TO CONNECT ANALOGUE LEVEL SENSOR 23 417 ..................8 9. TECHNICAL SPECIFICATION ......................... 9 SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc. -
Page 3: Introduction
The MPDM should be connected to 110VAC/60Hz power using load, neutral and ground. Balcrank recommends that the connection is done through a double pole lockable working switch. The “knock-out” holes on the lower right hand (see picture) should only be used for main power supply to separate it from the circuit board (DC) side of the module. - Page 4 Synergy – Tank Surveillance Module 3110-021 SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc.
-
Page 5: Card Connectors
The RESET-button (B) can be used to reset the module or reset the module address. Power supply is connected to the connector (C). NOTE! Check polarity, GND is closest to the hole! SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc. -
Page 6: To Connect Discrete Level Sensors 23 132/138/171 And Solenoid Valves
Verify the function and trim it by moving the clips if necessary. The floater is a little conic and the small diameter should then be down. SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc. -
Page 7: Fresh Fluid, 23183 (1-Level)
To do this the current sum of all solenoids has to be calculated. If it is below 1A one TSM port cam be used. If it is over 1A 2 or more ports must be used or a relay has to be used. SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc. -
Page 8: Ex-Barrier 23187
To achieve a proper function, that is the pump starts only if there are enough oil in the tank, a dispense point is open and the sensor works properly, the following connection should be made. SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc. -
Page 9: Connecting A Waste Oil Tank 23132 (2-Levels)
0.5 mm2 for each lead. For this purpose use the by-packed connection box. It is not necessary to use the shield to obtain a good signal because the signal SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc. -
Page 10: Technical Specification
500 mA + 4x1.25 A for solenoid valves Casing: Strong black powder painted steel box Outer measures: 303 x 228 x 65 mm. Fitting: 4 x ø5mm CC = 250 x 175 mm Weight: 3,9 kg SERVICE BULLETIN SB 3077 Rev. A 3/12 Balcrank Corporation, Inc.
Need help?
Do you have a question about the Synergy 3110-021 and is the answer not in the manual?
Questions and answers