Digiplex DGP-848 Programming Manual

S
DEFAULT INSTALLER CODE
000000
(see section [800] on page 39)
DEFAULT SYSTEM MASTER CODE
123456
HOW DO I ENTER PROGRAMMING MODE?
1) Press and hold the [0] key.
2) Enter your [
INSTALLER CODE
3) Enter 3-digit [
SECTION
4) Enter required [
DATA
DECIMAL AND HEXADECIMAL PROGRAMMING TABLE
Certain sections may require the entry of one or more Hexadecimal values from 0 to F.
For LCD keypads:
[0] to [9] = values 0 to 9 respectively
[ ] = A
STAY
[ ] = B
FORCE
[ ] = C
ARM
[ ] = Save current data and advance to next section
ENTER
For Grafica keypads:
[0] to [9] = values 0 to 9 respectively
# = A to F (press the [#] key until the desired letter
[ ]
appears)
ECURITY AND
P
ROGRAMMING
].
].
].
Digiplex DGP-848
A C
CCESS ONTROL
G
Software Version 4.0
DGP-848
[ ] = D
DISARM
[ ] = E
BYP
[ ] = F
MEM
[ ] = Exit section without saving
CLEAR
Right Action Key (Exit)
Center Action Key (Save) =Save current data and advance to next
- 1 - Programming Guide
(DGP-848)
UIDE
= Exit section without saving
section