Abrasive Delivery from the Pot to the Regulator ..................3 Regulator Startup .......................... 4 Metering Regulator Flow Rate ........................4 Moisture or Water ............................. 5 Disassembly and Reassembly ........................6 Drawings and Parts Lists ......................7 13096 Abrasive Regulator II...
Customer Service Representatives are available to take your calls Monday through Friday 7:00 AM to 5:00 PM CST. If you need service after-hours AccuStream is also on-call 24 hours a day, 7 days a week to ensure your system is up and running around-the-clock.
Use ¼” (6 mm bolt) cap screws for mounting the regulator. 4. Re-thread the tie rods back into their original locations. Rear Tie Rod Picture may differ from your regulator 13096 Abrasive Regulator II Manual...
Different hose lengths after the split will cause uneven abrasive pressure on the regulators. This can cause different abrasive flow rates between the regulators. 13096 Abrasive Regulator II Manual...
5. Reconnect the regulator base and hose. Any moisture reaching the regulator, from piercing should THUMBNUTS be minimized. It is best to use a splashguard on the nozzle. 13096 Abrasive Regulator II Manual...
On the assembly drawing cut-out, (right) note the location and thickness of Sandwich plate and the Exit plate. The 0.50 dimensions and plate thickness will determine the orientation and placement of both parts. 13096 Abrasive Regulator II Manual...