Specifications; Accessories Included; Troubleshooting; Warranty - Vision TECHCONNECT IR Owner's Manual

SPECIFICATIONS

• Dimensions: 71 x 42 x 40mm
• Weight: 63 grams
• Colour: White
Note: Because we are committed to improving
our products, the details above may change
without prior warning.

TROUBLESHOOTING

If your system is not operating properly, please refer to the following information. If the problem
persists, disconnect from power and contact your AV reseller immediately.
Problem
No sound when front buttons pressed
Module fails to learn the code
Module learns code and makes sound
but doesn't control the projector

WARRANTY

This product comes with a 2-year return to base warranty, effective from the date of purchase.
This warranty applies only to the original purchaser and is not transferable. For the avoidance
of doubt, this will be taken from the information held by the appointed national distributor at the
point of sale. If the product is DOA (dead on arrival), you have 21 days from purchase date
to notify the national distributor via your AV reseller. The liability of the manufacturer and its
appointed service company is limited to the cost of repair and/or replacement of the faulty unit
under warranty, except for death or injury (EU85/374/EEC). This warranty protects you against
the following:
• Failure of any components.
• Damage when the product is first removed from its packaging if reported within 24 hours of
purchase.
If you find you do have a problem with this product, you should contact the AV reseller you
purchased this product from. The original purchaser is responsible for shipment of the product to
the manufacturer's appointed service centre for repair.
We will endeavour to return repaired units within 5 working days, however this may not always
be possible, in which case it will be returned as soon as practicably possible. In line with our
WEEE commitments, the manufacturer endeavours to replace the faulty parts of the product
rather than replacing the whole unit. This warranty does not protect this product against faults
caused by abuse, misuse, incorrect installation, unstable or faulty power input, which might be
caused by ignoring the guidelines set out in this manual.
6

ACCESSORIES INCLUDED

9 x Interchangeable button sets
1 x Single-Gang Techconnect Backbox
1 x Single-Gang Techconnect Surround
1 x IR Blaster with 10m cable
2 x AAA Batteries
Correction
Replace the batteries.
Make sure the original remote is 30-50mm away
from the receiver on the back of the module, and at
90 degrees.
Make sure the original remote has fresh batteries.
When teaching hold down the button on the original
remote for longer until the green LED lights on the
Module.
Re-program the buttons.
Re-position the IR blaster.
Check IR blaster cable to make sure it hasn't been
damaged during installation.