Operation - HAMPTON BAY 19274-002 Use And Care Manual

Operation and assembly
1.
Operation the lamp
To Use as a Table Lamp:
Place lamp base (A) on a stable lamp surface.
Adjust lamp Shade (B) to desired position by
adjusting the Shade Knob (C) located on the lamp
Shade (B). Lamp Shade (B) adjusts to180 degrees.
Insert Plug (D) into an electrical outlet.
Use Switch (E) to turn lamp on and off.
2.
Assembly the lamp
To Use as a Wall Mounted Lamp:
Use a pencil to mark the location on the wall
for the Screw Anchor (G).
Make a hole slightly smaller than the diameter
of the Screw Anchor (G).
Insert the Screw Anchor (G) and tap into the hole
in the wall until secure.
Set the Anchor Screw (H) into the Screw Anchor (G).
Leave enough of the Anchor Screw (H) exposed so
the Keyhole Slot (F) may be set on the wall.
Align the Keyhole Slot (F) on the lamp Base (A)
with the Anchor Screw (H) .
Gently push lamp Base (A) toward wall to secure
lamp Base (A) to Anchor Screw (H) and wall.
Insert Plug (D) into an electrical outlet.
Use Switch (E) to turn lamp on and off.
E Switch
G Screw Anchor
(not included)
Hole
H Anchor Screw
(not included)
WALL
4
B Shade
D Plug
C Shade Knob
A Lamp Base
F Keyhole Slot
A Lamp Base