Inspection I - BMW 323i 2000 Service And Warranty Information

Inspection I

Only those items of inspection work which apply to your vehicle will be performed. This list is subject to amendment.
Undercarriage
Change oil and oil filter while engine is at normal operating temperature.
Check transmission for leaks.
Check rear axle for leaks.
Half-shafts: Check for leaks at flexible boots.
Visually check fuel tank, lines and connections for leaks.
Check condition, position, and mounting of exhaust system. Examine for leaks.
Check power steering system for leaks. Check power steering fluid level; add fluid if necessary.
Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage and joint disc.
Check overall thickness of front and rear disc brake pads using special tool. If replacement is necessary: Examine brake disk surfaces.
Clean brake pad contact points in calipers. Grease wheel centering hubs. Check thickness of parking brake linings only when replacing
rear brake pads.
Check brake system connections and lines for leaks, damage and incorrect positioning.
Check parking brake actuation. Adjust if necessary.
Check all tire pressures (including spare). Correct if necessary. Check condition of tires (outer surface [left/right]),
tread wear and pattern; in case of uneven tread wear, readjust wheel alignment if requested (invoice separately).
Inspect entire body according to terms of rust performation limited warranty.
(must be performed at least every two years).
Engine Compartment
Read out diagnostic system.
Check engine cooling system/heater hose connections for leaks. Check coolant level and antifreeze protection level.
Add coolant if required.
Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if required.
Check air conditioner for operation.
Replace microfilter. (Note: reduce replacement interval in dusty operating conditions.)
Reset service interval indicator.
7
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•