Summary of Contents for Reliance Controls The Home Protectors 11034
Page 1
INSTALLATION INSTALLATION INSTALLATION AND OPERATING INSTRUCTIONS OPERATING OPERATING INSTRUCTIONS INSTRUCTIONS WIRELESS FREEZE FREEZE / / / FLOOD FLOOD WIRELESS WIRELESS FREEZE FLOOD WARNING FLASHER SYSTEM WARNING WARNING FLASHER FLASHER SYSTEM SYSTEM Model 11034 Model Model 11034 11034...
Page 2
INSTALLING REMOTE SENSING MONITOR TRANSMITTER INSTALLING INSTALLING THE THE REMOTE REMOTE SENSING SENSING MONITOR MONITOR TRANSMITTER TRANSMITTER Place the ON / OFF switch in the “off” position. Open the battery compartment on the back of the monitor. Connect a new 9-volt battery to the battery terminals. Replace the ...
Page 3
SETTING FLASHING STROBE ALERT RECEIVER SETTING SETTING UP UP THE THE FLASHING FLASHING STROBE STROBE ALERT ALERT RECEIVER RECEIVER Remove peel-off decal from flasher lens. Place the ON / OFF switch in the “off” position. Open the battery compartment on the back of the monitor. ...
The transmitter and receiver must be reset by turning both units off and then back on. IMPORTANT IMPORTANT IMPORTANT NOTE NOTE NOTE When the sensing monitor transmitter is triggered by low temperature or water, it will emit a continuous sharp beeping sound. To reset the unit and stop the beeping, turn the unit OFF and then ON.
Page 5
Make sure flood sensor probe is plugged into proper jack in transmitter, and is immersed in water Make sure transmitter is on Make sure transmitter battery is properly installed If AC adapter is used, make sure adapter is 9 volt DC, with a minimum output of 200mA Make sure receiver is on ...
Page 6
Warranty Warranty Warranty Reliance Controls Corporation warrants this product to be free from defects in material and workmanship under normal use for a period of one year from date of purchase, provided the product has been installed and used in accordance with Reliance's instructions and has not been subjected to misuse, alteration, modification, accident, or repair not performed by Reliance.
Page 7
STATEMENT FCC STATEMENT STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.