Summary of Contents for Castel SAT802
- Page 1 ShenZ hen CASTLWireless ShenZ hen CASTELWireless China Aerospace Telecommunications Limited Telecommunications CO .,LTD. SAT802 Product User Manual for Iridium/GPRS Dual mode communication terminal...
- Page 2 Warning! 1. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 3 1 Definition 1.1 Hardware interface SAT802 host provides five external interfaces, that's Power supply & Data transmission interface, Handset interface, Iridium antenna interface, GSM antenna interface and GPS antenna interface as shown below. 1.1.1 Definition of power supply & data transmission interface...
- Page 4 interface. Baud rate: 8N1, 9600bps。 Pin 6 Black Ground Ground Pin 7 Orange ISO_VIN Isolated VIN Pin 8 Yellow ISO_GND Isolated Ground Pin 9 Green GPIO1 The state of this bit can be configured as either an input or an output. The input bit can be configured either for voltage input or for grounding input.
- Page 5 Indicator 1.1.2 Multi-function cable DB15 Port Power supply & Data DB9 Port Standard RS232 To make user connect the device easily, there is a set of cable provided with the device. One side of the cable connects “Power & Data”port of the device. Thereare two types of signal at the other side, power parts and RS-232 femaleconnector.
- Page 6 RS232 standard serial port which also has data t function. ransparent transmission Detailed setting commands see "User Communication Protocol" part in Auxiliary《SAT802 Communication Protocol.pdf》. 2.3 Working mechanism of data transparent transmission Any data not being above-mentioned parameter format that terminal serial port received will be considered as "user transparent transmission data", and according to channel status, data...
- Page 7 3) Fix the side plate to the main unit, fasten the screw and secure it. 3.2 Placement of SAT802 main unit The location for placement of the SAT802 main unit should be determined in advance. The location should allow anti-humidity, avoidance of high-temperature area, and be far away from magnetic field and other sensitive electronic equipment.
- Page 8 15 degrees. Besides, it must be fixed securely and far from GSM antenna. It is recommended that the distance between Iridium antenna and GSM antenna should be no less than 1.5m. Warning!: Any change of the GPS, GSM and Iridium antennas’ feedback cable may affect the normal working of the SAT802.
Need help?
Do you have a question about the SAT802 and is the answer not in the manual?
Questions and answers