Asus ZenFlash AFLU002 User Manual page 4

Using ZenFlash with your ZenFone
1. Take out your ZenFlash from the silicon case.
2. Pull out the USB cable from the bottom of your ZenFlash.
3. Peel off the covering of the adhesive transparent pad on the back of
the hoop and loop fastener set.
4. Firmly position your ZenFlash under the rear camera of your ZenFone.
5. Connect the micro USB cable to your ZenFone.
6. Launch the ZenFlash app on your ZenFone and start shooting.
NOTE: The transparent adhesive pad (with non-water-soluble glue) can
be used repeatedly. If dirty, rinse it and allow to air-dry before reuse.
IMPORTANT!
• For accurate responses, use your ZenFone without a case or sleeve.
• Ensure the photodiode of your ZenFlash and the LED flash of your
ZenFone are placed in a straight line.
• The distance between the photodiode and your LED flash has to be no
more than 4 cm.
• Ensure your ZenFlash does not block the LED flash on your ZenFone.
• For better result, use your ZenFlash in low-light conditions and keep it at
least 1 meter away from your subject.