JABSCO 23680-4003 Installation Instructions

FEATURES:
Continuous rated, medium duty pumps for
bilge and general purpose use.
ISO 8846 MARINE (Ignition protection).
ISO 8849 MARINE (Bilge pump standard).
bilge debris present no problem to
Small
these bronze bodied, flexible impeller
pumps.
Simple design means fewer wearing
parts.
32 lpm (6.5 UK gpm) output @ 3m (10ft)
head.
Self priming to 1.2m (4 ft).
WATER PUPPY PERFORMANCE
Approximate performance for new pump,
running water at 20°C with fully charged battery
TOTAL HEAD
m ft
2 7
3 10
4 13
6 20
WARNING:
repeatedly do not fit a heavier fuse or
bridge the fuse terminals with silver
paper or metal wire. Failure to observe
this instruction may result in a fire
hazard due to overheating of cables.
WARNING: Do not use any Jabsco
pump for petrol, petroleum products or
any products with a flash point below
37°C (98°F), explosion or death may
occur.
WATER PUPPY
lpm UK gpm
35 7.7
32 7
30 6.6
25 5.5
If the fuse fails
COMMERCIAL DUTY
MODELS:
23680-4003 12V DC
23680-4103 24V DC
INSTALLATION INSTRUCTIONS
Jabsco Water Puppy can be mounted on any flat
surface. Fit the pump
position where there is full access for service. If
installed in a vertical position the motor must be
above the pump head. Use the rubber grommets
provided to minimise vibration, do not overtighten the
mounting screws.
Secure 25mm (1") id hose either direct to the
discharge ports or to ½" BSP male threaded fittings
using stainless steel hose clamps. Use spiral
reinforced hose (with a smooth internal bore) that will
not collapse under suction, or rigid or semi rigid
pipework systems. The pipework must be compatible
with the liquid being pumped. Pipe runs should be
kept as straight and short as possible, avoiding rising
and dipping over obstructions. Fit a strainer on the
inlet hose to prevent larger debris from entering the
pump.
WIRING INSTRUCTIONS
Make all electrical connections in dry locations,
connections in humid environments should be sealed
to prevent corrosion. Protect the circuit with a
correctly rated fuse or circuit breaker in the orange
positive (+) lead as close as possible to the power
source. Connect the black motor wire to the negative
(-) battery terminal. Inadequate voltage at the motor
terminals when the pump is running (not less than
10% below rated voltage at full load) due to partially
discharged batteries or insufficient cable size may
result in blowing fuses, failure to start or poor pump
performance.
WARNING:
discharging
installed with the overboard discharge
well above both static and heeled
waterlines.
WATER PUPPY
in a dry, well ventilated
All marine
overboard
:
pumps
must be