Advertisement
Kit Includes
•
Bow Air Bag
•
Set Webbing Straps
•
Flotation Tangs with Screws and Washers
•
Wood Blocks with Fiberglass Patches
Additional Material Required
•
Resin
•
Gel Coat
•
3" disposable bristle paint brush
•
Acetone
•
Rags
Before Beginning Please Thoroughly Read Through All Instructions.
Please call us at 1-800-864-7208 with any questions.
Wood Block Installation
1. In order to provide maximum lift, the bag should be secured to the floor of the boat just forward of the
centerboard trunk. Use the sketch to locate the position for the wood blocks.
2. Lay the uninflated air bag in the bow to be sure the position of the blocks is correct.
These instructions are intended for the exclusive use of Flying Scot, Inc. customers. Any unauthorized use is strictly prohibited.
Bow Air Bag Instructions
•
•
•
•
•
80 Grit Sandpaper
Hammer
Cordless Drill w/ 1/8" bit
Phillips Screwdriver
Tape Measure
Advertisement
Table of Contents
Summary of Contents for Flying Scot Bow Air Bag
- Page 1 Use the sketch to locate the position for the wood blocks. 2. Lay the uninflated air bag in the bow to be sure the position of the blocks is correct. These instructions are intended for the exclusive use of Flying Scot, Inc. customers. Any unauthorized use is strictly prohibited.
- Page 2 Note: Be sure not to drill more than 3/4” deep. A hole drilled too deep can easily go through the bow and show on the outside. 3. Screw the tang down using the washer on the center screw. These instructions are intended for the exclusive use of Flying Scot, Inc. customers. Any unauthorized use is strictly prohibited.
- Page 3 Note: Be sure not to drill more than 3/4” deep. A hole drilled too deep can easily go through the bow and show on the outside. These instructions are intended for the exclusive use of Flying Scot, Inc. customers. Any unauthorized use is strictly prohibited.
Need help?
Do you have a question about the Bow Air Bag and is the answer not in the manual?
Questions and answers