Advertisement
Operation
1. Place the Digital Scale on a
flat surface in the work area.
2. Press the ON/TARE button once.
The Scale will start operating.
When "0" "and" " 0 " appear
on the digital display, the
Scale is ready for weighing.
3. Gently place item to be weighed
on platform. The weight will
appear on the display.
4. When weighing substances that
must be put into a container
(such as powders or liquids), place
empty container on Scale platform.
Press ON/TARE button.
The digital display will return
to zero, adjusted to ignore
weight of empty container and
only weigh contents.
A " 0 " readout will appear in
lower left corner of display.
5. Place contents into container.
The weight of contents only will
appear on the digital display.
6. To turn off Scale, press the OFF
button. The Scale is also equipped
with an auto shut-off function.
The scale will automatically turn off
40 seconds after item is weighed.
Changing Weight Unit
1. When turning on Digital Scale,
the default weight unit is
always "g" (grams).
2. When there is no item on the
platform, the "g" indicator on the
upper right corner of the digital
display will light on and point to "g".
Item 95364
For technical questions, please call 1-888-866-5797.
3. Press MODE to change weight
unit from "g" to "oz" (ounces)
or to "lb" (pounds).
Calibrating the Scale
1. To Calibrate, or balance, Scale,
press CAL for three seconds.
Once the display shows "CAL",
stop pressing button.
2. Press CAL button again. Place an
item that weighs exactly 5.5 lb.
(2500 G) on scale. Press CAL
button again. The display will show
"0". Keep the item on the platform
3. Place another item weighing 5.5 lb.
on platform. Press CAL again. The
display will show "ACC", meaning
the Scale is successfully calibrated.
Troubleshooting
1. Digital display flashes "LO":
Battery charge is low.
Replace battery or use Adaptor
to ensure accuracy.
2. Display doesn't respond
to controls:
Circuit needs to be reset.
Remove the battery,
wait 30 seconds, replace battery
and turn the Scale "ON".
3. Display does not show:
Battery has poor connection
or battery voltage is too low.
Take battery out and adjust
connections. Replace the battery
as necessary or use Adaptor.
Page 3
Advertisement
