Summary of Contents for Shenzhen Tozed Technologies G8504
- Page 1 GSM FIXED WIRELESS TERMINAL G8504 USER MANUAL GSM FIXED WIRELESS TERMINAL USER MANUAL...
-
Page 2: Table Of Contents
Table of Contents 1.Introduction………………………………………………………… 2.Safety Information………………………………………………… 3.Product Composition………………………………………….… 4.Features………………………………………………….………. 5.User Instruction………………………………………….……… .7-9 6.TechnicalSpecifications………………………………………… 9-10 7.Troubleshooting………………………………………..………. 11-12 8.Important Notices…………………………………………….….. GSM FIXED WIRELESS TERMINAL USER MANUAL... -
Page 3: Introduction
1．Introduction: 1．1 GSM FIXED WIRELESS TERMINAL, when linked with a telephone set, allows you to connect and communicate flexibly within GSM cellular network coverage. GSM FIXED WIRELESS TERMINAL. 1.2 Thank you for your use of this Please kindly follow this user manual to unpack, set up and operate your new GSM FIXED WIRELESS TERMINAL product. -
Page 4: Safety Information
2.Safety Information: Using any wireless device will interfere with nearby electronic equipment，So please read the following information carefully and deal with the packing in proper way to avoid any pollution. 2.1Aircraft: Do not use this GSM FIXED WIRELESS TERMINAL in the air. Use it on the ground only with crew permission. -
Page 5: Features
c. Power Supply Adaptor: AC/DC adaptor, with charging circuit inside for the charging of batteries. 4.Features: 4.1 Outgoing Calls: When GSM FIXED WIRELESS TERMINAL has been arranged for working, pick up the handset of a normal DTMF/DIAL PULSE telephone set linked to the terminal and dial your number after hearing the dialing tone. - Page 6 4.6.2 Cancellation of Speed Dial programming: Get the FIXED WIRELESS TERMINAL ready for working (connected with a normal telephone set); Pick up the telephone handset; Press **51*speed dial code#; Programming completed after confirmation tone. 4.6.3 Using of speed dial: Get the FIXED WIRELESS TERMINAL ready for working (connected with a normal telephone set);...
-
Page 7: User Instruction
off, the FIXED WIRELESS TERMINAL fails to get registered. 4.7.3 Phone; Indicator light for “In Use”, When the telephone set is picked up, this light is on; when the telephone set is hung up, this light is off; when there is an incoming phone, this light blinks every 100ms;... - Page 8 5.3 AC/DC adaptor: Notices: 1. please use only the rechargeable batteries designated by supplier or measured up to the standard of Radio Communication Industry. 2. No using regular batteries without rechargeable function 5.4 Installation Procedures: PLEASE FOLLOW STEP BY STEP. 5.4.1 SIM Card Installation: GSM network operators will provide one SIM card for each terminal.
-
Page 9: Technicalspecifications
5.4.5Indicator Light Checking: The power indicator light should blink; GSM signal strength indicator lights may glint first and will stabilize 20 to 30 seconds later indicating the present signal strength. To achieve best voice quality, please use mobile tray antenna. 5.4.6 Completion of Installation: Till now the installation process is completed, you may try dialing. - Page 10 GSM1800 Transmission:1710-1785MHz Reception: 1805-1880MHz Carrier Spacing: >200 KHz Transmitting power: ≤ 30/33dBm+2dB Maximum Frequency Deviation: ±0.1 ppm Receiving Sensitivity: <-102 dBm Modulation type: GMSk SIM Card: Mini-SIM Card Dimensions: 182.56*135*42.29 MM Weight: 1Kgs Work Voltage：AC220V±15% DC 6.5V ±0.5V Working Temperature Range: 0℃～+40℃ Humidity Range: ≤5%--95% 6.2 Antenna: Frequency Bandwidth: 890-960MHZ...
-
Page 11: Troubleshooting
7. Troubleshooting: Please refer to the following table for possible trouble if the indicator light for PWR is steadily on or you cannot dial any number after the power supply is on. Number Binary Code Designation ST0 ST1 ST2 〇〇〇 No signal Network registration 〇〇●... -
Page 12: Important Notices
See if the connection between the antenna and the terminal is tight or not; See if the antenna is placed in a vertically upright position and if the antenna is far away from any barrier. ※ The antenna should be as far away from the telephone line and power supply line. Do not wind the antenna line with the telephone line as this may cause GSM electronic-magnetic wave interference in power supply and telephone line.
Need help?
Do you have a question about the G8504 and is the answer not in the manual?
Questions and answers