Advertisement
MFJ-1124/1126/1128/1129 DC Power Outlets
Model Maximum
Current
(amps)
MFJ-
40
1124
MFJ-
40
1126
MFJ-
40
1128
MFJ-
40
1129
POWERPOLE® CONNECTOR ASSEMBLY
These units use Anderson Powerpole
connectors exclusively).Your power strip package includes both plastic connector housings and terminals
®
for making Powerpole
First, slide two connector housings together to match the configuration of the corresponding connectors
on your power strip. It's easier to do this now rather than after the wired terminals have been inserted in
the housings.
You can install the Powerpole
make sure you have good, solid connections. Wires smaller than 12 gauge will not allow for crimping,
and must be soldered to the terminals.
To crimp, first strip the wire, making sure not to damage the wire strands. Insert the wire into the terminal
and crimp. Be careful not to deform or squash the terminal body. If you do, crimp again to return it to its
original shape. Otherwise, the terminal may not fit inside the housing. Be sure that you have a good firm
connection to reduce resistance.
If you solder wires to the terminals, tin them lightly first. When soldering, flow solder only into the hole
in which the wire is inserted. Be careful not to get any solder around the outer body of the terminal.
PowerPole
Binding
pairs
post
pairs
4
2
8
0
12
0
7
3
®
connectors (the MFJ-1126 and MFJ-1128 use Powerpole
plugs. The terminals accommodate wires from 12 to 16 gauge.
®
connectors on your wires by either soldering or crimping, as long as you
Un-
Switched
switched
pairs
pairs
6 FUSED
3 FUSED
5 FUSED
3 FUSED
9 FUSED
3 FUSED
7 FUSED
Fig 3: Correct orientation of terminal and
housing.
Fig 4: Using an insertion tool to snap
terminal in place. A very small, flat-blade
screwdriver will work.
Fig 5: Assembled terminal and housing.
2
Instruction Manual
DC
On-
Main
volt
Off
fuse
meter
switch
NO
NO
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
®
Advertisement
