Table of Contents
Advertisement
PROBLEM
Engine Will Not Start
1. Fuel tank empty or fuel valve OFF.
Using Recoil Starter
2. Engine needs choking.
3. Spark plug wire disconnected.
4. Engine speed control in STOP position.
1.
Engine Stalls or Stops
After Running
2.
3.
4.
5.
Engine Loses Power
1. Engine air pre-cleaner or air cleaner dirty.
2. Spark plug faulty.
3. Water, debris or stale fuel in fuel system.
Excessive Vibration
1. Damaged, out of balance or bent mower blades.
2. Loose blade components.
3. Loose or missing air lift (if equipped).
4. Lumpy or frayed belt.
5. Bent Idler pulley.
1. Damaged transmission.
Mower Will Not Move
Loss Of Traction
2. Traction drive belt requires replacement.
(Self-Propelled Models) 3. Driven disc slipping.
1. Cutting height too low or high.
Cutting Grass
2. Engine speed too slow.
Improperly
3. Forward ground speed too fast.
4. Terraced cut, side to side.
5. Excessive deck pitch, front to rear.
6. Cutting blade(s) dull or damaged.
Poor Grass Discharge 1. Engine speed too slow.
2. Forward speed too fast.
3. Grass is wet.
4. Excessively worn or damaged blade(s).
5. Build up of grass clippings and debris under deck.
6. Improper blade(s) installed on deck.
7. Blade(s) installed improperly on deck.
1. Leaking engine case.
Oil Leaking
TROUBLESHOOTING
PROBABLE CAUSE
Choke control in the "CHOKE" position.
Fuel tank empty.
Engine air pre-cleaner and or air cleaner dirty.
Spark plug defective or gap set improperly.
Water, debris or stale fuel in fuel system.
1. Fill fuel tank with fresh fuel. Turn valve ON.
2. Move choke control to "CHOKE" position.
3. Place spark plug wire onto spark plug.
4. Move control to choke or fast position.
1.
Move choke control to "OFF" position.
2.
Fill with fuel to proper level.
3.
Clean free of all debris.
4.
Service spark plug.
5.
Drain and clean fuel system.
1. Clean or replace filters.
2. Service spark plug.
3. Drain and clean fuel system.
1. Service mower blade(s).
2. Service and tighten loose parts.
3. Replace air lifts. Tighten to proper torque.
4. Replace belt.
5. Replace pulley.
1. Contact authorized SNAPPER dealer.
2. Replace traction drive belt.
3. Clean or replace driven disc.
1. Adjust cutting height.
2. Move engine speed control to "FAST" position.
3. Move ground speed control to a slower speed.
4. Adjust height of cut with height adjust levers.
5. Adjust height of cut with height adjust levers.
6. Sharpen cutting edges or replace blade(s).
1. Move engine speed control to "FAST" position.
2. Move ground speed control to a slower speed.
3. Mow when grass is dry.
4. Service mower blade(s).
5. Clean deck.
6. Install proper SNAPPER blades.
7. Install blades properly.
1. Contact authorized SNAPPER dealer.
2. Check and tighten drain plug.
3. Make sure dip stick or oil filler cap is securely
in place.
19
CORRECTIVE ACTION
Advertisement
Table of Contents
