Screwdriver Safety Warnings - Ryobi R4SDC Original Instructions Manual

manufacturer or authorized service
providers.

SCREWDRIVER SAFETY WARNINGS

■ Hold the power tool by insulated
gripping surfaces, when performing
an operation where the fastener may
contact hidden wiring. Fasteners
contacting a "live" wire may make
exposed metal parts of the power tool
"live" and could give the operator an
electric shock.
■ Ambient temperature range for tool
during operation is between 0°C and
40°C.
■ Ambient temperature range for tool
storage is between 0°C and 40°C.
CHARGER SAFETY WARNINGS
■ Before using battery charger, read all
instructions and cautionary markings
in this manual, on battery charger,
battery, and product using battery to
prevent misuse of the products and
possible injury or damage.
■ Do not use charger outdoors or expose
to wet or damp conditions. Water
entering charger will increase the risk
of electric shock.
■ Use of an
recommended or sold by the battery
charger manufacturer may result in a
risk of fire, electric shock, or injury to
persons. Following this rule will reduce
the risk of electric shock, fire, or serious
personal injury.
■ Do not abuse cord or charger. Never
use the cord to carry the charger.
Do not pull the charger cord rather
than the plug when disconnecting
from receptacle. Damage to the cord
or charger could occur and create
an electric shock hazard. Replace
4
attachment not
damaged cords immediately.
■ Make sure cord is located so that it
will not be stepped on, tripped over,
come in contact with sharp edges or
moving parts or otherwise subjected
to damage or stress. This will reduce
the risk of accidental falls, which could
cause injury, and damage to the cord,
which could result in electric shock.
■ Keep cord and charger away from
heat to prevent damage to housing or
internal parts.
■ Do not operate charger with a
damaged cord or plug, which could
cause shorting and electric shock. If
damaged, have the charger replaced
by an authorised serviceman.
■ Do not operate charger if it has
received a sharp blow, been dropped,
or otherwise damaged in any way.
Take it to an authorised serviceman
for electrical check to determine if the
charger is in good working order.
■ Do not disassemble charger. Take it
to an authorised serviceman when
service or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
■ Unplug charger from outlet before
attempting any
cleaning to reduce the risk of electric
shock.
■ Disconnect charger from the power
supply when not in use. This will
reduce the risk of electric shock or
damage to the charger if metal items
should fall into the opening. It also will
help prevent damage to the charger
during a power surge.
■ Risk of electric shock. Do not touch
uninsulated portion of output connector
or uninsulated battery terminal.
■ Do not recharge primary cells (non-
maintenance or