Quick Start - Jomurema JR128-R01-RTR Instruction Manual

5. Quick Start:

Carefully unpack all items from your box and check for completeness,
comparing the content with the listing from page 3 and 4 of this manual.
Please follow precisely the step by step description here below for starting running
and having fun with your new model car:
STEP 5.1:
Charging of the 1S / 3.7V / 25C / 840 mAh Lipo Battery, included in this set:
ATTENTION: Read page 7 & 8 of this manual (about Lipo batteries) well before starting
your first charging procedure.
Before running your model for the first time, charge your 1S Lipo Battery with the included
charger from this box. For any further charging cycles follow the same charging instruction.
Plug the charger always first to the socket (STEP 1.1)
and afterwards plug the Lipo Battery to
the charger (STEP 1.2). Red light on the charger
shows you, that your Lipo battery is charging.
When the red light on your charger changes into green
your battery is fully charged and should be unplugged
immediately from the charger after the full green light
has appeared.
After having unplugged the Lipo battery from the
charger, unplug charger from the socket.
STEP 5.1.2:
After plugging Charger to
the socket, plug Lipo Battery to the Charger.
(RED LIGHT on charger: "CHARGING";
GREEN LIGHT: "READY CHARGED"):
9
JR128-R01 - RTR
STEP 5.1.1:
always first to the socket:
STEP 5.1.3:
After light on charger has
changed to green unplug the Lipo battery
immediately from the charger. Then unplugg
charger from the socket:
QUICK START (5.)
Plug Charger