Advertisement
Quick Links
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes
to review this manual before you start installation. If you encounter any
installation or performance problems, please don't hesitate to contact us.
Our phone numbers are listed on the back cover. Thanks again for choosing
Kohler Company.
Tools and Materials
Before You Begin
Read the installation guide carefully and install the product accordingly.
The product information contained in this publication is correct at the time
of printing. Kohler Co. reserves the right to implement changes or product
characteristics, packaging and availability at any time without further notice.
Do not use corrosive cleaners or solvents in or on the tank. This may damage
the tank. Do not use any spare parts which are not suppled by Kohler.
Kohler will not be responsible for any damage due to the installation
of non approved spare parts.
Warning
This product is designed for a water supply pressure range of 20 psi
(137kPa) minimum to 80psi (550 kPa) maximum.
Any installations where the supply pressure is outside of these limits
will not be covered by warranty.
1122791 -A02-G
Apr 2019
1
Installation Instructions and
Home Owner's Guide
Mechanical In-Wall Cistern
Without Frame (Slim)
10611A-NA
477A-CP
75981T-CP
8857A-CP
75890T-CP
Kohler New Zealand
Advertisement
Summary of Contents for Kohler 10611A-NA
-
Page 1: Before You Begin
Do not use corrosive cleaners or solvents in or on the tank. This may damage the tank. Do not use any spare parts which are not suppled by Kohler. Kohler will not be responsible for any damage due to the installation of non approved spare parts. - Page 2 Fit the in wall tank to the stud’s using the tek screws ensuring the centre of the water inlet is at the correct distance above the finished floor level. 1122791 -A02-G Apr 2019 Kohler New Zealand...
- Page 3 finished floor level is correct. Cut the wall lining to suit the position of the flush plate, waste pipe, flush Wall Lining pipe and toilet fixing holes. Fit the wall lining to the stud. 1122791 -A02-G Apr 2019 Kohler New Zealand...
- Page 4 This connection distance is the distance between the rear of the tank and the hole in the wall lining. Mark Showing Position of Toilet Rear Waste Pipe Connection Distance Flush Pipe 1122791 -A02-G Apr 2019 Kohler New Zealand...
- Page 5 Unthreaded lock nuts to prevent adjustment over time. e locking plate and push the cover into the position. Cover Cover Locking Lock Plate Full Reduced Flush Flush 1122791 -A02-G Apr 2019 Kohler New Zealand...
- Page 6 Valve Leg 6. Turn the water off at the shut off valve inside the tank. Unscrew the fill valve fixing nut and remove the fill valve. Shut off valve 1122791 -A02-G Apr 2019 Kohler New Zealand...
- Page 7 Valve Leg 6. Turn the water off at the shut off valve inside the tank. Unscrew the fill valve fixing nut and remove the fill valve. Shut off valve 1122791 -A02-G Apr 2019 Kohler New Zealand...
- Page 8 10. Lift and rotate the flush valve until 11. Rotate the base of the flush valve it is horizontal. out through the access panel. 12. To replace the flush valve, follow this instruction in reverse order. 1122791 -A02-G Apr 2019 Kohler New Zealand...
-
Page 9: Troubleshooting Procedures
Adjust the inlet valve to an appropriate position Tank does not stop The outlet valve is not sealing Uninstall the outlet valve, check the filling correctly seal, replace if warn. Remove any debris and reinstall. 1122791 -A02-G Apr 2019 Kohler New Zealand...