Getting Started - AIPTEK MyNote Bluetooth Manual

MyNote Bluetooth Manual
Power LED:
Battery Status:
Bluetooth LED:

Getting started

1. Charge the Battery
2. Power On
3. Write a Note
Blink slowly in standby mode; blink quickly during writing.
Blink slowly during charging or when battery is low; steady on when fully
charged.
Blink slowly when bluetooth is on.
Before using MyNote Bluetooth the first time, the battery needs to be charged.
Connect the device with the supplied USB cable trough the USB connector and
the other side to a powered PC, Mac or notebook. After 3 hours the unit is fully
charged and ready to use.
The device turns on automatically once you open the folder, the
indicator starts blinking. Put the folder on a flat surface and
make sure that the base unit is located on top of the paper and
the holes of the receiver are not covered.
Pick up the digital pen coming with your MyNote Bluetooth and
write normally. If signals are received from the pen, the
indicator in blinking fast.
www.aiptek.eu
EN
Page 5