JABSCO 30510-3 Series Manual

SELF-PRIMING PUMPS
FEATURES
Pump Type: 30510-5XXX Close Coupled
30510-3XXX Pump Head
Body: Epoxy Plastic
Impeller: Neoprene, Nitrile, Viton* or EPDM
Shaft Seal: Mechanical, Carbon-on-Ceramic or
Tungsten Carbide; Nitrile or Viton
Ports: 3/4" NPT External
Shaft: Epoxy Plastic Covered Stainless Steel
Motor: 115 Vac, Single Phase, 60 Hz, 3/4 HP,
1750 RPM, TEFC, 56C Frame,
C-Face, Overload Protected,
Capacitor Start.
Weight: 30510-5XXX 35.0 lb (15.9 kg) Approx.
WARNING
Explosion hazard. Motor can spark. Explosion
!
& death can occur. Do not use where flammable
vapors are present.
30510-3XXX 6.5 lb (3.0 kg) Approx.
APPLICATIONS
INDUSTRIAL: Circulating and transferring corrosive
liquids. Returning spilled liquids to process. Transferring
foaming solutions with entrained air, such as soaps and
detergents. Sampling and pilot plant installations.
Handles pure solutions, acids, alkalies, photochemicals,
dyes, detergents, waxes, gels, solutions with suspended
solids and emulsions.
METAL PLATING: Filtration of plating solutions. Filling
and emptying vats. Adding chemicals for pH balance.
PHARMACEUTICAL:
medicines, lotions
pharmaceutical solutions.
AGRICULTURAL: Transferring
herbicides and pesticides.

OPERATING INSTRUCTIONS

1. INSTALLATION – Pump may be mounted in any
WARNING
!
Explosion Hazard. Do not pump gasoline, solvents, thinners
or other flammable liquids. To do so can cause an explosion
resulting in injury or death.
* Viton is a registered trademark of Du Pont Dow Elastomers L.L.C.
Processing lab solutions,
and preparations. Filtering
liquid fertilizers,
VARIATIONS AVAILABLE
Model Description
30510-5001 Standard Pressure, Neoprene Impeller,
30510-3001 Carbon Seal
30510-5003 Standard Pressure, Nitrile Impeller,
30510-3003 Carbon Seal
30510-5004 Standard Pressure, Viton Impeller,
30510-3004 Carbon Seal
30510-5101 Standard Pressure, Neoprene Impeller,
30510-3101 Tungsten Carbide Seal
30510-5103 Standard Pressure, Nitrile Impeller,
30510-3103 Tungsten Carbide Seal
30510-5104 Standard Pressure, Viton Impeller,
30510-3104 Tungsten Carbide Seal
position. The rotation of the pump shaft determines
the location of the pump's intake and discharge
ports. (Refer to dimensional drawing.) Pump is
normally assembled at factory for clockwise rotation
(looking at end cover). If counter clockwise rotation
is desired, follow steps 1 and 2 of disassembly and
step 7 of assembly instructions to change direction
of impeller blade deflection under cam.
2. MOTOR SELECTION – Pump head is designed to
fit a 56C Frame NEMA C-face motor. Motor should
be rated 3/4 horsepower at 1750 RPM with a
service factor of one. Due to high bearing loads,
MODEL 30510-5XXX
30510-3XXX