JABSCO 30510-5 Series Manual

SELF-PRIMING PUMPS
FEATURES
Pump Type: 30510-5XXX Close Coupled
30510-3XXX Pump Head
Body: Epoxy Plastic
Impeller: Neoprene, Nitrile, Viton* or EPDM
Shaft Seal: Mechanical, Carbon-on-Ceramic or
Tungsten Carbide; Nitrile or Viton
Ports: 3/4 " NPT External
Shaft: Epoxy Plastic Covered Stainless Steel
Motor: 115 Vac, Single Phase, 60 Hz, 3/4 HP,
1750 RPM, TEFC, 56C Frame,
C-Face, Overload Protected,
Capacitor Start.
Weight: 30510-5XXX 35.0 lb (15.9 kg) Approx.
30510-3XXX 6.5 lb (3.0 kg) Approx.
WARNING
!
Explosion hazard. Motor can spark. Explosion
& death can occur. Do not use where flammable
vapors are present.
APPLICATIONS
INDUSTRIAL: Circulating and transferring corrosive
liquids. Returning spilled liquids to process. Transferring
foaming solutions with entrained air, such as soaps and
detergents. Sampling and pilot plant installations.
Handles pure solutions, acids, alkalies, photochemicals,
dyes, detergents, waxes, gels, solutions with suspended
solids and emulsions.
METAL PLATING: Filtration of plating solutions. Filling
and emptying vats. Adding chemicals for pH balance.
PHARMACEUTICAL:
medicines, lotions
pharmaceutical solutions.
AGRICULTURAL: Transferring
herbicides and pesticides.
OPERATING INSTRUCTIONS
1. INSTALLATION – Pump may be mounted in any
position. The rotation of the pump shaft determines
the location of the pump's intake and discharge
ports. (Refer to dimensional drawing.) Pump is
WARNING
!
Explosion hazard. Do not pump gasoline, solvents,
thinners or other flammable liquids. To do so can
cause an explosion resulting in injury or death.
* Viton is a registered trademark of Du Pont Dow Elastomers L.L.C.
Processing lab solutions,
and preparations.
liquid fertilizers,
VARIATIONS AVAILABLE
Model
30510-5001
30510-3001
30510-5003
30510-3003
30510-5004
30510-3004
30510-5101
30510-3101
30510-5103
Filtering
30510-3103
30510-5104
30510-3104
normally assembled at factory for clockwise rotation
(looking at end cover). If counter clockwise rotation
is desired, follow steps 1 and 2 of disassembly and
step 7 of assembly instructions to change direction
of impeller blade deflection under cam.
2. MOTOR SELECTION – Pump head is designed to
fit a 56C Frame NEMA C-face motor. Motor should
be rated 3/4 horsepower at 1750 RPM with a
service factor of one. Due to high bearing loads,
motor should be ball bearing equipped with the front
bearing locked against axial movement. Motor
should be capacitor start and foot mounted.
Model 30510-5XXX
30510-3XXX
Description
Standard Pressure, Neoprene Impeller,
Carbon Seal
Standard Pressure, Nitrile Impeller,
Carbon Seal
Standard Pressure, Viton Impeller,
Carbon Seal
Standard Pressure, Neoprene Impeller,
Tungsten Carbide Seal
Standard Pressure, Nitrile Impeller,
Tungsten Carbide Seal
Standard Pressure, Viton Impeller,
Tungsten Carbide Seal