Subscribe to Our Youtube Channel
Summary of Contents for LigoWave LigoPTP 3-N
- Page 1 LigoPTP 3-N Quick Installation Guide Revision 1.0 August 27, 2008 Copyright © 2008 LigoWave www.ligowave.com...
-
Page 2: Copyright
This user’s guide and the software described in it are copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of LigoWave. Notice LigoWave reserves the right to change specifications without prior notice. -
Page 3: Fcc Warning
FCC rules CFR47 part 15.204. The installer should configure the output power level of antennas, according to country regulations and per antenna type. Professional installation is required of equipment with connectors to ensure compliance with health and safety issues. LigoWave Page 3... -
Page 4: Antenna Compliance
Antenna Compliance The LigoPTP 3-N radio module is compliant with any antenna of lesser or equal gain as specified in the chart below given channel bandwidth and radio conducted power. A higher gain antenna may be used if radio conducted power is lowered. For every 1dBm that the radio’s conducted power is lowered, an increase of 1dB may be added to the allowed antenna gain assuming the total EIRP does not exceed the Limit in the following table. -
Page 5: Table Of Contents
Package Contents ..........................7 Hardware Introduction ......................... 7 General Overview ..........................7 Connectors ............................8 Mounting the LigoPTP 3-N ........................9 ACCESS THE LIGOPTP 3-N ....................... 10 Connection via WEB browser ......................10 Resetting to Factory Defaults ......................11 LigoWave... -
Page 6: About This Guide
Purpose The purpose of this guide is to provide a quick and easy explanation of getting started with the LigoPTP 3-N. This is only a starter guide and full documentation may be found at our online wiki: http://www.ligowave.com/wiki Definitions, Acronyms and Abbreviations The following typographic conventions and symbols are used throughout this document: Additional information that may be helpful but which is not required. -
Page 7: Installation
If any of these items are missing or damaged, please contact your reseller or LigoWave sales representative. Hardware Introduction General Overview The LigoPTP 3-N is housed in an aluminum enclosure and features an N-female type connector for use with external antennas. The bottom panel of the LigoPTP 3-N contains: ... -
Page 8: Connectors
Quick Installation Guide Installation Connectors The LigoPTP 3-N has several connectors on the bottom and side panels. Descriptions of the connectors are given in the following table: Connector Description For insertion of power and data through Ethernet cable using passive PoE... -
Page 9: Mounting The Ligoptp 3-N
Quick Installation Guide Installation Mounting the LigoPTP 3-N LigoWave Page 9... -
Page 10: Access The Ligoptp 3-N
Access the LigoPTP 3-N The first connection to the LigoPTP 3-N can be made using a standard Ethernet cable connected directly to your PC. See next sections for the instructions on how to access the LigoPTP 3-N management interfaces. Connection via WEB browser The default IP address of the LigoPTP 3-N is 192.168.2.66 with a subnet mask of 255.255.255.0. -
Page 11: Resetting To Factory Defaults
Access the LigoPTP 3-N Resetting to Factory Defaults LigoWave products have the capability of being reset to defaults by pinging the device with a certain packet size when the radio is booting. During the startup of the device, when the drivers of the ethernet interfaces are loaded, the discovery daemon is started.
Need help?
Do you have a question about the LigoPTP 3-N and is the answer not in the manual?
Questions and answers