Summary of Contents for YGHP 30
- Page 1 HOUSEHOLD ELECTRIC WATER HEATERS 30-120 designed for wall installation MANUAL FOR INSTALLATION, OPERATION AND MAINTENANCE...
- Page 2 Water inlet Wasseranschluss Entrée de l'eau Water outlet Ablauf Wasser Sortie de l'eau Combined valve Kombiniertes Ventil Soupape combiné Switch Schalter Bouton Thermostat Thermostat Thermostat Anode tester Anodentester Testeur anode Electronic control Elektronischen Steuereinheit Unité de commande électroniques Inlaat water Intrare apă...
- Page 4 Water inlet Wasseranschluss Entrée de l'eau Water outlet Ablauf Wasser Sortie de l'eau Heat exchanger I Wärmetauscher I Échangeur de chaleur I Heat exchanger II Wärmetauscher II Échangeur de chaleur II Thermostat coupling Thermostatmuffe Douille de thermostat Inlaat water Intrare apă Вход...
- Page 6 EN – for water pressure in the mains above 0,5 MPa DE – bei Wasserleitungsdruck ab 0,5 MPa FR – lorsque la pression de l'eau dans le conduit passe au-dessus de 0,5 MPa NL – wanneer de waterdruk van de waterleiding meer dan 0,5 MPa is RO –...
- Page 7 While the units themselves can often be simple to install to comply with UK laws all installers must be unvented certified. If you are unsure on how to fit the unit please contact YGHP to prevent any install damages.
-
Page 8: Environmental Protection
WARNING! Before installation and operation with the appliance, read carefully the present manual! guide for use by qualified persons who will install and repair the KEY REQUIREMENTS FOR SAFETY unit in case of failure. Installation and commissioning of the unit is Before starting the installation of your appliance and its operation it not a warranty obligation of the seller and/or manufacturer. -
Page 9: Technical Description
The water heater power (excluding those with letters "D" and "C") coverage and the heat insulation is made of CFC-free is 1,5 kW for the units in volume group 30, up to 2 kW for the units in polyurethane foam. - Page 10 material. The heat-transfer liquid must be with temperature not WARNING! The bearing plates of horizontal water heaters higher than 85 °С and in its circuit must be installed a control must be securely clamped to the premise wall. Under the bolts device set at this temperature in order not to allow thermal cut-out heads (nuts on studs) must be placed support washers! of the electrical heating element during normal operation.
- Page 11 џ instructions provided by the company responsible for the wait for about 30-60 seconds until a thick and powerful installation and connection of the heater design. It is mandatory to stream of water runs out from the valve side opening.
- Page 12 complete disconnection from power supply takes place from the obligatory to install an electric fuse 10 А for water heater electric capacity up to 2 kW and 16 A for electric capacity of 3 kW. The additional disconnecting device. electric installation to which the heater will be connected must be For models marked with the letter "D"...
-
Page 13: Additional Corrosion Protection
This is done by lifting tank is full. The anode is a consumable (i.e. a device with normal the lever, and wait for 30-60 seconds from the side opening the wear during the appliance operation) and its average operational valve to flow thick and strong jet of water. -
Page 14: Warranty Conditions
Keep the warranty form in a secure place. SHALL NOT AFFECT PRODUCT SAFETY. In all instances shall be in force the applicable laws, regulations MANUFACTURED IN EUROPE FOR YGHP WITH ALL UK and other legislation dealing with the rights and obligations of WARRANTY BEING SUPPORTED BY YGHP.
Need help?
Do you have a question about the 30 and is the answer not in the manual?
Questions and answers