2、Central lock wiring diagram △ This operation instructions is for T360-500, please read them before use Product overview Amwell GSM auto security System is the new version of car one-way or two-way alarms system. Which combines the GSM mobile communication, GSM locating technology and MECROCHIP rolling code technology, multi-code mating and microcomputer technology.
Product components Installation wiring Diagram 1、Wiring Diagram for base unit T360-500:one base unit ,one wireless remote keyboard, one shock sensor, siren, loudspeaker, one antenna, one relay, one emergency button, one LED indicator , microphone ,12 PIN harness,10PIN harness, user manual.
Page 5
(1) Check whether GSM signal is OK. (2) Check Whether SIM Card touches properly. (3) Check whether cut off the power source and the back-up battery when inserting Planform for accessories the GSM card. (4)Open the ACC, meanwhile press the emergency button for 5 times, direction lights flash 3 times, the system will reset again Problem 2: Calling the controlling phone numbers when there is no alarm triggered Solution:...
Page 6
Accessories: storage in -40~+100℃ Working temperature: -20~+85℃ Working humidity: 25%~95% (6) Dimension of base unit T360-500: 120mm*83mm*35m Installation notices (1) First, make sure that the back-up battery is off. Use tools to take out the SIM card slot, insert the SIM card into it according to the shape of the card slot and then put it into base...
3. Check the remained money of the SIM card in time Detail functions introduction 4. Keep vehicles under the signal of GSM. 1. Wireless keyboard operation 5. Secret the password of the main unit. Change the password once it is disclosed (1) Menu function of keyboard Press the “*”...
Attention: The system can only identify the set-up controlling phone number if SIM (2) Under system armed: LED lightning for twice and stop lightning for 5 card have call ID function. seconds… Within this 5 seconds, LED indicates GSM signal<same as (1)> 1、Inquiry Contact with the base unit through the four controlling phone numbers, enter (3)Alarm is Triggered by vibration: LED shining for three times and stop lightning...
Page 9
During the speaking, press “2” to start monitoring meanwhile press “3” to speak turn to calling these two numbers till some answer to the call (7)Trunk release alarm again. Under system armed status, if someone releases the trunk illegally, direction light flash for 25 seconds, meanwhile, siren chirps.
Page 10
If you want to delete password, voice prompts “please enter password and press “#” 3. Alarm to finish, only press “#”without any number, then system prompts “your enter (1)Shaking alarm Press the “Arm” button on the existing or factory-installed remote transmitters, password is *****”...
Need help?
Do you have a question about the T360-500 and is the answer not in the manual?
Questions and answers