Advertisement
A, under the power-on condition for controller, no receiver is found over 55 seconds;
B, Under the power-on condition for controller, no any operation acts on any button or axes over 10
minutes;
2). To exit sleep mode, press HOME button, and the current port LED indicator illuminates.
6. FC function (short for "Force Connection")
1)
You can assign a RF controller to an appointed receiver when many RF controllers work in the
same operating instance. (Please follow step connection and installation 3-6 for force connection)
2)
After well connected, wireless controller and it's receiver will be partnered automatically
If you want to change the receiver or controller, you should have to force connect again(Please follow
3)
step connection and installation 3-6 for force connection)
7. Low-voltage alert function
When battery is weak or empty, the current port LED indicator would flash to indicate that the
rechargeable batteries need to be replaced or plug the mini usb cable to the controller power supply.
8. RESET function:
If the controller experience unexpected disconnection, drain, or voltage surge protection, it may not be able
to connect, or be connected but without any function, you need to switch the power switch to OFF and then
to ON for resetting:
9. Battery Safety
1) Batteries are to be inserted with the correct polarity
2) Use only the recommended batteries
3) Do not mix old & new batteries
4) Do not mix Alkaline, Standard (Carbon Zinc) or rechargeable (Nickel-Cadmium) batteries
5) Dispose of batteries safety & correctly
6) Do not dispose the batteries into fire, batteries may explode or leak
7) Remove batteries if the controller will not be used for a long period of time
8) Exhausted batteries should be removed from the controller immediately
9)
Don't charge non-rechargeable batteries
Advertisement
