EFX 500c1 Installation Manual

1-CHANNEL (MONO) AMPLIFIERS
500c1
- 18dB Adjustable Full/Low Pass
- Electronic Crossover (40Hz~400Hz)
- 2-Ohm Load Capability
1000c1
- 18dB Adjustable Low Pass
- Electronic Crossover (40Hz~200Hz)
- 1-Ohm Load Capability
- Strapable
500c1 SPECIFICATIONS
Power Output:
Signal to Noise Ratio:
Additional Power Output:
Frequency Response:
Maximum Input Signal:
Minimum Input Signal:
1000c1 SPECIFICATIONS
Power Output:
Signal to Noise Ratio:
Additional Power Output:
Frequency Response:
Maximum Input Signal:
Minimum Input Signal:
BEFORE YOU BEGIN:
Read all instructions and Cautions.
Disconnect Negative terminal of Vehicle battery.

Installation procedures:

Plan your installation completely before beginning.
Be sure you have all materials needed to complete your installation.
Please call us with any questions before you start at:
Tools & Supplies
Wire Strippers and Cutters
Drill and Drill Bits
Electrical Tape
Location/Mounting Amplifier
Select a safe/dry location to mount your Amplifier. Double check location and placement of
your amplifier before making any connections or drilling any holes. Never mount your Amplifier
in the engine compartment, or cover it with carpet or any other fabric materials that will cause
the Amplifier not to get the proper ventilation. Avoid drilling through electrical wires, fuel lines,
or other obstructions that may be around your mounting area. If you have any questions or
concerns, please contact our tech support team at 1-800-621-3695 Ext. 3
EFX AUDIO IS A DIVISION OF SCOSCHE INDUSTRIES, INC. ©2009
INSTALLATION MANUAL
EFX AMPLIFIER FEATURES
350 Watts RMS x 1 Channel at 4 Ohms and 1% THD+N
>80 dBA (reference:1 Watt into 4 Ohms)
500 Watts RMS x 1 Channels at 2 Ohms at 1% THD+N
20Hz -20kHz (-3dB)
6V (Low Level) / 10V (High Level
200mV (Low Level) / 420mV (High Level)
350 Watts RMS x 1 Channel at 4 Ohms and 1% THD+N
>80 dBA (reference:1 Watt into 4 Ohms)
500 Watts RMS x 1 Channels at 2 Ohms at 1% THD+N
1000 Watts RMS x 1 Channels at 1 Ohms at 1% THD+N
20Hz -200Hz (-3dB)
6V (Low Level) / 10V (High Level)
200mV (Low Level) / 420mV (High Level)
IMPORTANT/ PRELIMINARY
Digital Multi-Meter
EFX Amplifier Wiring Kit, EFX REVOPAK4 is
recommended for these amplifiers.
500c1/1000c1
- 0-12dB Variable 45Hz Bass Boost
- RCA Line Level Output Loop-Thru
- Line Level & Speaker Level Inputs
- Soft Start Turn-on/off
- 5-Way Protection (Thermal, Short Circuit,
Impedance, Voltage, Reverse Polarity)
- MOSFET Power Switching Transistors
- Brushed Aluminum Heatsink and Top Plate
- Sturdy Aluminum Side Panels
- Illuminated Logo Badge
500c1/1000c1 02.09