Table of Contents
Advertisement
• Close the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.
Important Note: Under normal use conditions, the batteries
in the mobile will require replacement more often than the
batteries in the remote. When you notice that the sound
slows down and is affected by the light display or when the
sound or lights become faint or movement of the mobile
sluggish, it's time to replace the batteries in the mobile.
Remote
• Locate the battery compartment door on the back of
the remote.
• Unfasten the screw in the battery compartment door with
a Phillips screwdriver.
• Open the battery compartment door and insert two size
"AA" (LR6) alkaline batteries in the correct polarity as
indicated in the battery compartment.
• Close the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
Important Note: If the mobile does not respond to use of
the remote it does not necessarily mean that the battery
power in the remote is low. Replace the batteries in the
remote if the LED signal indicator on the remote is dim
when the button is pressed. If the LED signal indicator does
not light after installing new batteries in the remote, check
the orientation of the batteries in the battery compartment to
make sure they are properly installed.
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Battery
leakage and corrosion can damage the product. Dispose
of batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recom-
mended in the "Battery Installation" instructions are to
be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
product before they are charged.
Battery Installation
Battery Tips
5
Advertisement
Table of Contents
