Brackets Assembly Madjax recommends professional installation. If you choose to not have this product installed by a professional, we highly recommend that you exercise caution, care, and patience when installing this product as it involves drilling holes into your cart’s body.
Page 2
With the help of an assistant mark the desired location you want to mount the fan. Use a tape measure to square the brackets to ensure proper alignment. NOTE: For single person install removing the roof is ideal for the next four steps. Also be wary of mounting fan in a location that will obstruct other accessories.
Page 3
Additionally, the Madjax Voltage Reducer Harness, 13-017 is recommended when using the 16-12 Volt Reducer. NOTE: The fan will mount to the TXT, and Star cart floor. Madjax does not recommend a floor mounted fan location on the Club Car, *E-Z-GO , and YAMAHA vehicles ®...
Page 4
Find desired location as high up floor board as possible. Mark locations of bolt holes with a marking pen. Caution: Before drilling into floor board be sure there are no obstructions on opposite side Using a 1/4” Drill bit for the bolt holes drill through floor board.
® ® marks, or products is only for purposes of identifying golf carts with which this Madjax product is compatible. Madjax products are aftermarket parts and are not original equipment parts. Madjax is not connected to, affiliated with, sponsored by, or endorsed by Ingersoll Rand or any of its subsidiary companies.