1. Manuals
  2. Brands
  3. Alanco Technologies, Inc. Manuals
  4. GPS
  5. TSI PRISM PSD3G
  6. User manual

Alanco Technologies, Inc. TSI PRISM PSD3G User Manual

Hide thumbs
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
PSD3G User's Guide
Confidential
Property of Technology Systems International, Inc.
Copy and Distribution Only With Permission
Revised: 12/19/07

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TSI PRISM PSD3G and is the answer not in the manual?

Questions and answers

Summary of Contents for Alanco Technologies, Inc. TSI PRISM PSD3G

  • Page 1 PSD3G User’s Guide Confidential Property of Technology Systems International, Inc. Copy and Distribution Only With Permission Revised: 12/19/07...
  • Page 2 INTRODUCTION PURPOSE The PSD2 improves prison guard safety. The PSD2 Distress Button allows a guard to summon help with the push of a button. The PRISM system tracks the location of each guard so help can arrive promptly. The PSD2 also monitors whether or not a guard is moving and upright and if the PSD2 is attached to the guard’s belt.
  • Page 3 The LED will flash RED if the battery cannot be charged within a programmable amount of time, typically four hours (See Command B in Appendix B for more information about setting the charger timeout time). This will most likely happen if the battery is defective or if the battery is so completely discharged that it cannot be recharged within the programmed time.
  • Page 4 2.4.4 ACCELEROMETER WARNING AND ALARM DISPLAY A 10-second audio warning is issued if the PSD3G is tilted over 60 degrees from vertical for 10 seconds or is motionless for 120 seconds (programmable). This is followed by a 10-second alarm if the Down condition is not corrected before the alarm starts sounding. The warning sound is two 200mS tones alternatively repeating followed by 800mS of silence.
  • Page 5 INSTALLATION The purpose of this section is to describe how to install a PSD Unit. INSTALLATION PROCEDURE Install PSD unit on belt by pulling clip away from housing and slipping unit over belt. Do not force the clip. Clip Squeeze PSD unit and Clip around belt, tighten thumb screw until screw is finger tight and clip alarm sounds.
  • Page 6 View of PSD Unit properly installed on belt.

  • Page 7: Regulatory Statement

    REGULATORY STATEMENT Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.

Table of Contents