Advertisement
Advertisement
Table of Contents
Summary of Contents for Alanco Technologies, Inc. TSI PRISM PASS3G
- Page 1 TSI PRISM PASS3G User’s Guide...
- Page 2 INTRODUCTION The PASS3G (Personal Active Secured Sensor, 3rd Generation) is part of Alanco Technologies’ TSI Prism System which is the premier safety technology for corrections environments, providing real time, continuous monitoring of inmates. The PASS3G is worn on the wrist and is used for location and identification of the individual wearing the unit.
- Page 3 To install the PASS3G, first insert the two tamper clips (one on each side) into the main PASS3G unit housing as shown above. Next place the bottom clip partially onto the main housing until there is approximately a 1/8 inch gap (resistance will be felt). Place the unit on the wrist of the wearer and push the strap through the housing until it is snug.
- Page 4 PASS3G REMOVAL The PASS3G is deactivated using the AeroScout Tag Manager application and the AeroScout Tag Activator. The unit is removed using a special removal tool. The removal tool fits over the top of the PASS3G unit. When the two handles of the removal tool are squeezed together the bottom plate of the PASS3G unit is released and the strap opens.
- Page 5 REGULATORY STATEMENT Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Need help?
Do you have a question about the TSI PRISM PASS3G and is the answer not in the manual?
Questions and answers