Enrollment Station Installation Instructions
Specifications
Mechanical:
2.74" W x 4.6" L x 1.4" H
Environmental:
Environment: For indoor use only.
Temperature Tolerance: -20º to 130º F
Description
The Enrollment Station is used to enroll HID format proximity cards directly into the PC software by
presentation. This provides a convenient way to enroll cards whether you know the card format or
not. The raw card data is read from the card and then stored in the PC software.
Packing List
1 Enrollment Station
1 Installation Instructions
1 12VDC, 300mA Transformer
1 6-foot straight cord
1 DB-9 Serial Connector
1 DB-25 Serial Connector
Operation
To operate the Enrollment Station simply connect power and connect it to your PC as shown in the
diagrams in the following sections. Once it's connected to your PC you are now ready to enroll your
cards. To enroll cards, present them over the labeled area on the top of the unit. When a card is
successfully read, the Enrollment Stations responds with an audible beep.
Document # 6055680 Rev 1.0, D1b
15.21 Information to User
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
Electrical:
Operating Voltage: 12 VDC
Current Draw: 20mA
1