Table of Contents
Advertisement
Disposal
Warnings for disposal:
–
It is prohibited to dispose of the appliance with normal or bulky household refuse.
–
Make sure that the cooling circuit, in particular the heat exchanger on the back, is not
damaged.
–
Ask your local authority or refuse disposal office for collection dates or the address of
suitable disposal sites.
Remove all protection fitted for transport
The appliance and some of its internal equipment are protected to avoid any possible
damage during transport. Before switching the appliance on, remove all adhesive tape,
protective sheets and any other packing and protective materials.
Tip: Remove any residual glue with solvent or benzene stain remover.
Installation
Positioning
Position the appliance in a dry, well-ventilated room.
Ambient temperature has an effect on energy consumption. You are therefore advised:
–
not to position the appliance in direct sunlight;
–
not to place it next to radiators, electric or gas cookers or any other source of heat;
–
to position the appliance so that the ambient temperature corresponds to the class
for which it is designed.
The class is shown on the rating plate located inside the appliance, on the left-hand side.
The table below shows the classes relating to various ambient temperatures.
If positioning the appliance next to a heat source is inevitable, maintain the following min-
imum distances: 3 cm from electric cookers; 30 cm from oil or solid fuel stoves.
Otherwise a thermal insulation panel must be fitted between the heat source and the ap-
pliance.
If the appliance is positioned next to another refrigerator or freezer, a 5 cm gap is needed
to avoid the formation of condensation on the outer walls.
32
Class
for ambient temperature
SN
N
ST
T
from +10°C to + 32°C
from +16°C to + 32°C
from +18°C to + 38°C
from +18°C to + 43°C
Advertisement
Table of Contents
