Summary of Contents for PV Electronics GPS5
- Page 1 Assembly Notes And User Guide GPS5 Time Receiver For Nixie Clock GPS5 Time Receiver - 1 - Issue 1 (01 February 2018) www.pvelectronics.co.uk...
- Page 2 SMD Jack socket ocket GPS Module with with antenna M3 X 6mm screw M3 X 6mm screw M3 nut Self adhesive foam pad elf adhesive foam pad Heat shrink GPS5 Time Receiver - 2 - Issue 1 (01 February 2018 www.pvelectronics.co.uk...
- Page 3 GPS module. It helps to press with a hard surface, such as a small block of metal. Jack Socket Solder the jack socket to the adapter PCB. GPS5 Time Receiver - 3 - Issue 1 (01 February 2018) www.pvelectronics.co.uk...
- Page 4 PCB below the GPS PCB. Then fill the four holes with solder. Apply the Heat Shrink Slide over the heat shrink tubing and shrink over the assembly with a hot air gun. GPS5 Time Receiver - 4 - Issue 1 (01 February 2018) www.pvelectronics.co.uk...
- Page 5 CONFIGURING AND USING THE GPS5 TIME RECEIVER Refer to the manual for your clock to find the appropriate configuration settings to enable GPS reception, and set baud rate to 9,600 bps Place the module as close to a window as possible, for the best view of the sky.
Need help?
Do you have a question about the GPS5 and is the answer not in the manual?
Questions and answers