Nikko PT-24810 Owner's Manual

1/5 radio control motorbike

Advertisement

Quick Links

9.6V
Owner's Manual
Manuel du lutilisateur
Manual del Propietario
• Recharger la batterie avant d'allumer
Please read carefully before starting to operate.
Keep the display box and the manual for future reference.
Warning! Use under the direct supervision of an adult
Actual product may vary from illustration of this manual.
FEATURES
2-channel full function: Forward, left/ right turn and stop.
Electric Break System.
Beginner/ Expert setting is possible by changing the side bumper attachment position.
ATTENTTION: JOUET ELECTRIQUE
Non recommandé pour les enfants de moins de 8 ans. Comme aves tous les appareils électriques, des précaut
ons doivent être observées pendant la manipulation et l'emploi pour éviter toute décharge électrique.
Entrée: secteur 120 VAC, 60 Hz seulement
Sortie: 12VDC 200mA
PARENTS ATTENTION
Il est recommandé de vérifier périodiquement l'absence de risque potentiel sur ce jouet et tous les
accessoires et de réparer o remplacer les pieces potentieliement dangereuses.
Lisez attentivement ce manuel avant de commencer à utiliser le véhicule.
Conservez la boîte d'exposition et le manuel pour toute référence ultérieure.
Attention! A utiliser sous la supervision directe d'un adulte.
La moto contenue dans l'emballage peut ne pas correspondre exactement aux illustrations.
CARACTERISTIQUES
Fonction complète double canal: avant,
gauche/droite et arrêt.
Système de freinage électrique.
Il est possible de passer du mode débutant au mode expert en modifiant la position de la fixation
du pare-choc latéral.
Ó
É
PRECAUC
N: JUGETE EL
CTRICO
No recomendado para niños de menos de 8 años de edad. AL igual que con todos los productos eléctricos,
para evitar un shock eléctrico, se deben observar precauciones especiales al manipular y usar este juguete.
Entrada: Solamente 120 VAC, 60 Hz.
Salida: 12 VDC, 200mA
ATENCIÓN PADRES
Se recomienca que este juguete y todos sus accesorios sean examinados periódicamente para tratar
de encontrar peligros potenciales provocados por piezas que necesiten ser reparadas o cambiadas.
Lea estas instrucciones detenidamente antes de la utilización.
Guardar la caja y el manual para su consulta en el futuro.
!
Precautión! Úselo bajo la supervisión diercta de un adulto.
El producto real puede diferir ligeramente de las ilustraciones.
CARACTERÍSTICAS
Función total en dos canales :
Adelante, giro izquierda/derecha y paro.
Sistema de frenado eléctrico.
Se puede configurar como principiante o experto cambiando la posición del parachoques lateral.
KMNA-BIKE3B
NM0-010306
• Recharge the Battery
Before You Start to Operate
• Recargue la bateria antes de
empezar a jugar
PRINTED IN MALAYSIA
IMPRIME EN MALAISIE
IMPRESO EN MALASIA
Front & rear suspension.
3 bands selector switch.
Suspension avant arrière.
Sélecteur 3 bandes.
Suspensión delantera y trasera.
3 interruptor del selector de la banda.
English / Français / Español
NIKKO
PT-24810
BATTERY REQUIREMENTS
Vehicle : Ni-Cd rechargeable
Transmitter : 1 x 9V(006P)battery
PILES
Véhicule : a set de piles Ni-Cd
Emetteur : 1 pile 006p(9V)
PILAS USADAS
Vehiculo : Pack de bateria 1x
Transmisor : 1 pila de 9 V (006P)
12VDC, 200mA
battery pack
(9.6V, 600mAh- 650mAh)
rechargeables
(9,6V, 600mAh- 650mAh)
NiCd recargable
(9,6V, 600mAh- 650mAh)
3 BANDS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PT-24810 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nikko PT-24810

  • Page 1 9.6V English / Français / Español NIKKO PT-24810 Owner's Manual Manuel du lutilisateur Manual del Propietario • Recharge the Battery Before You Start to Operate 12VDC, 200mA • Recharger la batterie avant d'allumer • Recargue la bateria antes de empezar a jugar Please read carefully before starting to operate.
  • Page 2 CONTENTS Motorbike Transmitter Charger 9.6V Ni-Cd battery Stand Transmitter Antenna tube Side bumper 9 V(006P) battery Manual & sticker Battery lid antenna RECHARGING "WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT." * The newly purchased Ni-Cd pack is not charged. Charge before operating. Household socket 1.
  • Page 3: How To Install The Batteries

    PREPARATION FOR STARTING OPERATION 1. HOW TO ATTACH ANTENNA TUBE Antenna wire Antenna tube Insert the antenna wire through the antenna tube, then insert the tube into the antenna tube holder. If the antenna tube cannot be successfully inserted into the antenna tube holder, try holding the root of the antenna wire with one hand and extending the wire with the other hand.
  • Page 4 When installing a Ni-Cd battery pack, make sure that the power switch of the vehicle is OFF. Put the connector cable into the connector holder. Push and turn the battery stopper. Install the Ni-Cd battery into the motorbike. Slide the battery lid and remove. Return the battery lid to its original position.
  • Page 5: Beginner Mode

    TRANSMITTER FOR BOTH RIGHT-HANDED AND LEFT-HANDED USERS TURN OVER If you want to hold the transmitter with your right hand, pull the tab (as shown) and push 1) Pull in the steering control wheel until it protrudes from the reverse side. You can only control the vehicle from the side in which the steering control wheel is protruding.
  • Page 6 2. Extend the transmitter antenna. 3. Turn ON the power switch of the transmitter. (The LED will light up.) (You can control farther by lifting the transmitter higher) 4. Turn ON the motorbike power switch. Hold the transmitter with one hand, and carry the motorbike with another hand.
  • Page 7 Pull trigger to drive Low / High speed. Turn wheel to clockwise for right turn. Push trigger to EBS. Turn wheel to counterclockwise for left turn. Release trigger to stop. Release wheel to drive straight forward. CORNERING If you turn the steering wheel to the left or right, the rider figure will shift its position in that direction.
  • Page 8 3 BANDS FOR FREQUENCY 27 MHz AND 49 MHz, ALLOWS UP TO 6 BIKES TO RACE AT ONCE. 27MHz 49MHz WHERE TO PLAY MOTORBIKE Please select smooth surface for playing. Roads suitable for playing : Concrete without sand on the surface, asphalt surface without holes Roads not suitable for playing : Sandy concrete surface, asphalt with holes,...
  • Page 9 EXPERT MODE TECHNIQUE Forward Start High Speed EBS speed reduction Low Speed Braking point Steering (Right, Left) Cornering (EBS) High Speed EBS speed reduction Repeat . . .
  • Page 10 What is EBS (Electric Brake System)? without EBS EBS is used to electronically stop a running motor, and similar to an actual brake in a car, it enables stopping within a short distance. When the speed control trigger is pushed forward to one side, EBS starts to work and allows cornering in high speed.
  • Page 11 PRECAUTION When carrying the motorbike, do not lift the rider. Always use both hands to carry from the bottom of the motorbike. Otherwise the rider’s hand may come out of the motorbike handle, or the motorbike attachment may be damaged. If rider’s hand is not on the handle, insert the pillow ball which is attached to the handle onto the hole of the hand.
  • Page 12: Troubleshooting

    Read the following troubleshooting guides when you have TROUBLE SHOOTING trouble operating the motorbike. The motorbike does not move Cause Remedy The power of the transmitter’s or Ni-Cd Either replace the transmitter batteries, or battery pack is depleted. recharge the Ni-Cd battery pack. Change the direction of batteries.
  • Page 13 The RBRC program provides a convenient alternative to disposing nickel-cadmium batteries into the trash or municipal waste stream, which is illegal in some areas. Nikko America's payments to RBRC makes it easy for you to drop off the spent battery pack at local retailers who sell replacement nickel-cadmium batteries.

Table of Contents